User manual CANON GROSSFORMAT-DRUCKLÖSUNGEN BROCHURE

[. . . ] 4 Remove the BJ cartridge from its package, then remove the orange protective cap q and tape w. 1 2 NOTE Discard the cap and tape. Never attempt to reattach them to the BJ cartridge print head. IMPORTANT Store BJ cartridges out of the reach of children. If anyone inadvertently ingests ink, consult a physician immediately. Do not touch the metallic areas on the BJ cartridge. Do not touch these metallic areas. NOTE The ink in the BJ cartridge is difficult to clean up if spilled. [. . . ] Do not touch the metallic areas on the BJ cartridge. Do not touch these metallic areas. NOTE The ink in the BJ cartridge is difficult to clean up if spilled. Follow the precautions below when handling the BJ cartridge. Carefully remove packaging from BJ cartridges. Do not attempt to disassemble or refill BJ cartridges. Do not shake or drop BJ cartridges. 5 Align the slot in the cartridge with the yellow post in the fax, and with the label facing outwards, insert the BJ cartridge into the cartridge holder. Lower the cartridge lock lever until you hear a click to lock the cartridge in place. 6 Close the printer cover. The fax automatically prints a test page. If you have problems printing, see Chapter 9 of the User's Guide. IMPORTANT Do not try to manually move or stop the cartridge holder. Do not touch the components shown below or any metal parts. Ribbon cable Guide rail Round shaft Circuit board NOTE The yellow post (BJ cartridge guide) should be visible through the slot. Only one outgoing message, no longer than 20 seconds, can be recorded. TIME LEFT 19 3 Press [Stop] twice when recording is finished. 4 Press [TAM Mode] to set TAM MODE. When you set TAM MODE, the TAM LED lights up and the outgoing message is played. When you cancel TAM MODE, the TAM LED switches off. If you have any new telephone messages, the messages are played automatically. To cancel TAM MODE, press [TAM Mode] again. 12/20 NOTE :00 NO OGM is displayed on the LCD when no outgoing message has been recorded. If you have any new telephone messages, the TAM LED blinks and the number of messages appears on the LCD. The date and time when the telephone message was recorded, the number of telephone messages and the number of the message being played are displayed whenever a message is played. Select the Caller ID setting. If you have subscribed to a Caller ID service with your telephone company, set the CALLER ID setting to ON. The fax will display the caller's name and phone/fax number on the LCD when you receive a call. 1 Press [Function], then press [Start/Copy]. USER SETTINGS 2 Use [3] or [4] to select RX SETTINGS, then press [Start/Copy]. ECM RX 3 Use [3] or [4] to select CALLER ID, then press [Start/Copy]. [. . . ] 1 Press [Function], then press [Start/Copy]. USER SETTINGS 2 Use [3] or [4] to select RX SETTINGS, then press [Start/Copy]. ECM RX 3 Use [3] or [4] to select CALLER ID, then press [Start/Copy]. OFF 4 Use [3] or [4] to select ON, then press [Start/Copy]. [. . . ]