User manual CANON IMAGECLASS D1150 DATASHEET

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. [. . . ] The document sizes that this scanner can scan are shown below. Eject Direction (*1) Width Length (*2) Weight (*3) Feeding documents are separated (Page separation mode) Feeding documents are not separated (Bypass mode) Business Cards ID Cards U-Turn Path 2. 08" to 8. 62" (53 mm to 219 mm) 2. 75" to 14" (70 mm to 356 mm) 14 to 32 lb bond (52 to 128 g/m2) 0. 0024" to 0. 0059" (0. 06 mm to 0. 15 mm) 11 to 40 lb bond (42 to 157 g/m2) 0. 0020" to 0. 0079" (0. 05 mm to 0. 20 mm) Straight Path 2. 08" to 8. 62" (53 mm to 219 mm) 2. 75" to 14" (70 mm to 356 mm) 11 to 32 lb bond (42 to 128 g/m2) 0. 0020" to 0. 0059" (0. 05 mm to 0. 15 mm) 11 to 144 lb bond (42 to 546 g/m2) 0. 0020" to 0. 0026" (0. 05 mm to 0. 66 mm) Can be scanned Size: 2. 12" × 3. 37" (53. 9 mm × 85. 5 mm) Thickness: 0. 03" ± 0. 003" (0. 76 ± 0. 08 mm) without embossing Cannot be scanned (*1) The DR-4010C offers two document eject configurations: U-turn path (the document is ejected to the document eject tray at the front of the scanner) and straight path (the document is ejected to the back of the scanner. ) (See “Document Feed and Eject Tray, ” on p. 19. ) U-turn path Straight path Document eject tray 2 16 Basic Operation (*2) You can scan documents up to 39. 2” (1000 mm) long by setting the scanner to the Long document mode. For details, refer to the User Manual (electrical manual. ) (*3) The paper weights that can be used with the scanner vary depending on the document feed method (page separation mode or bypass mode. ) (See “2-3 Placing Documents, ” on p. 22. ) IMPORTANT A document must meet the following criteria to be scannable: • When scanning a multiple page document, pages of the same size, thickness, and weight must be grouped together. Scanning different sizes and types of paper together can cause the scanner to jam. • Scanning documents before the ink is dry can cause problems with the scanner. Always make sure that the ink on a document is dry before scanning it. • Scanning documents that are written in pencil or similar material have a tendency to make the rollers and scanning glass dirty, which can lead to smudges in the scanned image and transfer the dirt to subsequent documents. Always clean the internal parts of the scanner after scanning such documents. (See “Cleaning the Sensor Glass and the Rollers, ” on p. • When using the U-turn path, make sure to open the eject tray guide. If the guide is not opened, documents may fall off the tray and cause a paper jam. Basic Operation 21 Chapter 2 2-3 Placing Documents There are two methods for feeding documents, the Page Separation mode and Bypass mode. Feeding pages continuously from a stack of documents placed in the feed tray is called the Page Separation mode. Feeding documents one sheet at a time or feeding documents consisting of multiple pages that are attached, is called the bypass mode. The document feed method can be changed by moving the feed selection lever. IMPORTANT • Always smooth out any folds or curls in your documents before placing them into the feeder. If the leading edge of a document is curled, it may cause a paper jam. • When continuously scanning documents on thin paper in the page separation mode, the pages may become wrinkled or folded and cause a paper jam. If this happens, scan the document in the bypass mode. CAUTION • Before you place a document, check to make sure it does not contain paper clips, staples, or other small metal objects. These items may cause a fire or electrical shock, damage the document, or cause a paper jam or scanner malfunction. • Do not wear loose clothing or jewelry that may get caught in the scanner while you are using it. Be extra careful of neckties and long hair. [. . . ] 23 Documents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 DR-4010C monitor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 S Scanning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Selection Lever . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22, 25 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 Straight Path . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 T Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 E Easy Start Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]