User manual CANON IMAGEPROGRAF IPF770 BROCHURE

[. . . ] 30 seconds PUT IN CARTRIDGE Install the printhead. IMPORTANT · To turn off the machine, be sure to always press [ON/OFF(1sec. )]. This will ensure that the printhead is capped and prevent it from drying up. · If you are not using the machine for a long period of time, we recommend that you print (in black and color) or clean the printhead approximately once a month to maintain the printhead in good working condition. 1 Press [Open] q and lift up the scanning unit w. [. . . ] · If you are not using the machine for a long period of time, we recommend that you print (in black and color) or clean the printhead approximately once a month to maintain the printhead in good working condition. 1 Press [Open] q and lift up the scanning unit w. Then remove the tape A. IMPORTANT · Do not touch the metal rod or any parts inside the machine. · Do not turn off the machine when opening the scanning unit. q A w 2 Remove the printhead from its packaging, then remove the orange protective cap B. B IMPORTANT · Do not touch the electrical contacts C. C 3 Raise the lock lever D, then gently slide the printhead into the holder. Lower the lock lever. D IMPORTANT · Do not touch the lock lever once the printhead has been installed. Turn over to continue Install the ink tanks. 1 Start with the yellow ink tank. Pull the orange tape in the direction of the arrow and remove the plastic wrapper so you can see the air hole A. Turn the ink tank over so that the protective cap B is facing up. Then hold the ink tank as shown below and remove the protective cap B. B A LL U P B LL U P BC k T I-3 ank eY In Ye lo w Ink Tank BCI-3eY ap an PU SU M ad e in J D C NOTE · To avoid spilling ink, never press on the long sides of the ink tank C. · Once you remove the protective cap B, do not touch the ink port D. 2 Insert the ink tank (label-side up) into the correct slot (refer to the color guide on the printhead). Press down gently on the ink tank until an audible click is heard. 3 Repeat steps 1 and 2 to install the remaining magenta, cyan, and black ink tanks. 4 Close the scanning unit until it locks into place. Be sure to now align the printhead as explained in step 8. Align the printhead. NOTE · If you will be installing the MultiPASS Suite software, you can also align the printhead from the software. 11-1 of the Basic Guide. B C USB label A · Windows 98/Me/2000 users: Once connected, the USB driver will automatically be installed. · Windows XP users: Once connected, the "Found New Hardware Wizard" dialog box appears. Click [Install the software automatically], then click [Next]. 7 Follow the on-screen instructions to complete installation. If you wish to install any other software included in the CD-ROM, click [Install Easy-PhotoPrint] or [Install ScanSoft Omnipage SE]. 8 When installation is complete, restart your computer before using the MultiPASS Suite software. Once installed, the MultiPASS Toolbar will be displayed on the desktop: For details on using the MultiPASS Toolbar, see p. 9-1 of the Basic Guide. NOTE · Remember to register your machine to ensure product support. The serial number is located on the back of the machine. Congratulations!You have now completed your machine setup. Where to from here. . . Once you have completed all steps in this Set-Up Sheet, refer to the Basic Guide for basic operation instructions of all functions of your machine. [. . . ] The serial number is located on the back of the machine. Congratulations!You have now completed your machine setup. Where to from here. . . Once you have completed all steps in this Set-Up Sheet, refer to the Basic Guide for basic operation instructions of all functions of your machine. [. . . ]