User manual CANON IMAGERUNNER 1025 CANON GREEN TIPS FLYER

[. . . ] 2 Remove all shipping tapes from the exterior of the machine. Install the cartridge. 1 Remove the cartridge from the bag. Keep the bag in a safe place for future use. 2 Gently rock the cartridge several times to evenly distribute the toner inside. 3 Hold the cartridge on a flat stable surface with one hand, and break the tab and pull out the seal completely with the other hand. 4 Pull open the front cover. B A 5 Hold the cartridge so that the instructions (A) and the arrow (B) are facing up, and insert it in the machine horizontally as far as it will go. 6 Close the front cover of the machine. Assemble the cassette and load paper. 1 Insert the output tray into the front slot on the machine. 2 Pull out the paper cassette. 3 Attach the extension to the cassette. The slots are keyed and must be inserted at a 90° angle. [. . . ] Once inserted, fold the extension as shown . 4 Pinch and slide the rear paper end guide to match the size of paper. To load Legal-size paper: Pull the blue tab and extend the cassette as far as it will go. Keep the rear paper end guide to LTR size mark. If you are not using Legal-size paper, skip to the next step without extending the cassette. A 5 Load the paper into the cassette. Make sure the paper stack sits below the hooks (A). 6 Pinch and slide the side paper end guides to match the size of paper. B 7 Even out the edges of the paper stack. Make sure the height of the stack does not exceed the limit marks and that the side edges of the stack are below the hooks (B). 8 Insert the paper cassette back into the machine as far as it will go. NOTE If you do not completely insert the cassette into the machine, paper jams may occur. 9 Insert the tabs on the extension cover into the slots on the back of the machine, and carefully lower the cover until it sits on the cassette extension beneath it. IMPORTANT Do not load paper from the back of the machine. Doing so may damage the paper feeding assembly inside the machine. Connect the power cord. 1 Plug the power cord into the rear socket . Then connect the other end to the wall outlet . 2 The machine takes up to 3 minutes to warm up. To view the manuals in PDF format, Adobe Reader/Acrobat Reader/Acrobat is required. If Adobe Reader/Acrobat Reader/Acrobat is not installed on your system, please download it from the Adobe Systems Incorporated website (http://www. adobe. com). Congratulations!You have now completed the machine setup. Where to go from here. . . Once you have completed all steps in this document, see the Basic Guide for basic operations of all functions of your machine. For information on the driver software, see the Software Guide (included in the User Software CD). NOTE Remember to register your machine to ensure product support. The serial number is located on the back of the machine. Part no. [. . . ] The serial number is located on the back of the machine. Part no. Canon and imageCLASS are trademarks of Canon Inc. All other products and brand names are registered trademarks or trademarks of their respective owners. [. . . ]