User manual CANON IR1020-24 OG IR2018-30 SERIEN BROCHURE

[. . . ] CAUTION: Introduction TO REDUCE THE RISK OF ELECTRIC SHOCK AND TO REDUCE ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY. CAUTION: DISCONNECT THE MAINS PLUG FROM THE SUPPLY SOCKET WHEN NOT IN USE. CA-570 identification plate is located on the bottom. · Use of CV-150F/CV-250F DV cable is necessary to comply with the technical requirement of EMC Directive. 2 1_D74PAL_E(02-12) 03. 1. 27 7:15 PM Page 3 Reference Guide The following manuals are supplied with the camcorder: Digital Video Camcorder MVX150i/MVX100i Instruction Manual This manual explains the camcorder operations from basic video recording to the use of the full range of features. [. . . ] Connected device: Begin recording when the scene you wish to copy appears. Stop recording when copying is complete. Stop playback. 87 4_D74PAL_E(87-99) 03. 1. 28 2:26 PM Page 88 Connecting a Digital Video Device Refer also to the instruction manual of the digital video device. E Side with an arrow Signal flow 4 pin - 4 pin: CV-150F DV Cable (optional) 4 pin - 6 pin: CV-250F DV Cable (optional) 88 Editing 4_D74PAL_E(87-99) 03. 2. 11 5:43 PM Page 89 Recording from Analog Video Devices (VCR, TV or Camcorder) You can record videos or TV programs from a VCR or analog camcorder on the tape in the camcorder. Anomalous signals sent from the connected device may be recorded as anomalous picture (although it may not appear so on the screen), or it may not be recorded at all. You cannot record from tapes with copyright protective signals. Headphones cannot be used during analog line-in recording. If the AV/headphones terminal set to [PHONES H], it will automatically switch to [AV]. When connecting to a TV/video with SCART terminal, use a SCART adapter with input capability (commercially available). The supplied SCART Adapter PC-A10 is for output only. E CAMERA PLAY (VCR) CARD CAMERA CARD CAMERA 1. Connect the camcorder to the analog video device. See Playing Back on a TV Screen ( 38). 2. Set the camcorder to PLAY (VCR) mode and load a blank cassette. Unauthorised recording of these materials may violate copyright protection laws. E Copyright Signals During playback: If you try to play back a tape that contains copyright control signals for protection of software, "COPYRIGHT PROTECTED PLAYBACK IS RESTRICTED" appears for a few seconds and the camcorder displays a blank blue screen. You cannot playback the contents of the tape. During recording: If you try to record from software that contains copyright control signals for protection of software, "COPYRIGHT PROTECTED DUBBING RESTRICTED" appears. You cannot record the contents of the software. You cannot record copyright protection signals to a tape using this camcorder. Editing 91 4_D74PAL_E(87-99) 03. 2. 11 10:13 AM Page 92 Converting Analog Signals into Digital Signals (Analog-Digital Converter) E By connecting the camcorder to a VCR or 8mm video camcorder, you can convert analog video/audio signals to digital signals and output the digital signals via the DV terminal. The DV terminal serves as output terminal only. Headphones cannot be used during analog-digital conversion. Turn off all devices before starting the connections. Depending on the signal sent from the connected device, the conversion from analog to digital signals might not work properly (e. g. , signals that include copyright protective signals or anomalous signals such as ghost signals). When connecting to a TV/video with SCART terminal, use a SCART adapter with input capability (commercially available). The supplied SCART Adapter PC-A10 is for output only. [. . . ] 113, 000 pixels LCD screen: MVX150i: 3. 5 in. , TFT Colour, approx. 123, 000 pixels MVX100i: 2. 5 in. , TFT Colour, approx. 112, 000 pixels Microphone: Stereo electret condenser microphone Recording media: SD Memory Card, MultiMediaCard Number of recording pixels: Still image: 1280 × 960, 640 × 480 pixels Movie: 320 × 240 pixels (approx. 10 sec. ), 160 × 120 pixels (approx. [. . . ]