User manual CANON IR1020-24 SERIJA BROCHURE

[. . . ] To prevent accidents and damage, read the Safety Warnings (p. 8, 9) and Handling Precautions (p. 10, 11). Test the Camera Before Using Before using the camera, take a few test shots and check that the images are properly recorded on the memory card. If the camera or memory card is faulty and the images cannot be recorded or read by a personal computer, Canon cannot be held liable for any loss or inconvenience caused. Copyrights Copyright laws in your country may prohibit the use of your recorded images of people and certain subjects for anything but private enjoyment. Also be aware that certain public performances, exhibitions, etc. , may prohibit photography even for private enjoyment. Canon and EOS are trademarks of Canon Inc. [. . . ] The camera then automatically sets the aperture to obtain the proper exposure at the shutter speed you have set. f : Enables you to set the desired aperture. The camera then automatically sets the shutter speed (30 sec. - 1/250 sec. ) to obtain the proper exposure at the aperture you have set. Against dark backgrounds such as the night scenes, slow-sync shooting will be set so that both the subject and background are exposed correctly. The main subject is exposed with the flash, and the background is exposured with a slow shutter speed. Because automatic slow-sync shooting uses a slow shutter speed, always use a tripod. If you do not want a slow shutter speed to be set, set C. Fn-03 [Flash sync. (p. 168) a : You can set both the shutter speed (bulb or 30 sec. The main subject is exposed properly by the flash. The background exposure will vary depending on the shutter speed and aperture. 8 : The flash result will be the same as the <d> mode. 102 Using the Built-in Flash Built-in Flash Range With EF-S18-55mm f/3. 5-5. 6 ll ISO speed 100 200 400 800 1600 H: 3200 Wide angle: 18mm Approx. Red-eye To increase the effectiveness of red-eye reduction, reduction lamp press the shutter button down completely after the On indicator red-eye reduction lamp (which lights for approximately 1. 5 seconds) indicator goes off. You can shoot anytime by pressing the shutter button down completely, even while the red-eye reduction lamp is still on. The effectiveness of red-eye reduction varies from subject to subject. Red-eye reduction is more effective in brighter rooms or when the camera is closer to the subject. 104 Using the Built-in Flash A FE LockN FE (flash exposure) lock obtains and locks the correct flash exposure reading for any part of a subject. 1 Check that the <D> icon is lit. Press the <D> button to pop-up the built-in flash. Press the shutter button halfway and look in the viewfinder to check that the <D> icon is lit. subject. Keep Press the pressing the shutter button halfway until step 4. 3 Press the <A> button. (8) Aim the viewfinder center over the subject where you want to lock the flash exposure, then press the <A> button. The flash will fire a preflash and the required flash output is calculated and retained in memory. In the viewfinder, "FEL" is displayed for a moment and <d> will light. Each time you press the <A> button, a preflash is fired and the required flash output is calculated and retained in memory. 4 Take the picture. and press the Compose the shot shutter button completely. [. . . ] 17 Vivid. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 134 W Wallpaper . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 164 Warm tone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 134 WB-BKT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]