User manual CANON LV-7320 BROCHURE

[. . . ] If your projector seems to operate improperly, read this manual again, check operations and cable connections and try the solutions in the “Trouble-shooting” section of the end of this booklet. If the problem still persists, contact the sales dealer where you purchased the projector or the service center. SAFETY PRECAUTIONS WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. q This projector produces intense light from the projection lens. Do not stare directly into the lens as possible. [. . . ] Auto PC Adj. 1 2 Press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button to move a red frame pointer to PC ADJUST Menu icon. Press POINT DOWN button to move a red frame pointer to AUTO PC Adj. This Auto PC Adjustment can be also executed by pressing AUTO PC ADJ. button on Remote Control Unit. PC ADJUST MENU PC ADJUST Menu icon Move a red frame pointer to AUTO PC Adj. icon and press SET button. Store adjustment parameters. Adjustment parameters from Auto PC Adjustment can be memorized in this projector. Once parameters are memorized, setting can be done just by selecting Mode in PC SYSTEM Menu (P22). Refer to step 3 of MANUAL PC ADJUSTMENT section (P26). NOTE q Fine sync, Total dots and Picture Position of some computers can not be fully adjusted with this Auto PC Adjustment function. When the image is not provided properly through this function, manual adjustments are required. (Refer to page 25, 26. ) q Auto PC Adjustment function cannot be operated when “RGB, ” “720p (HDTV), ” “1035i (HDTV)” or “1080i (HDTV)” is selected on PC SYSTEM Menu (P22). 24 COMPUTER INPUT MANUAL PC ADJUSTMENT This projector can automatically tune to the display signals from most personal computers currently distributed. Press POINT LEFT/RIGHT button(s) to decrease/increase value and then press SET button. Display area V Adjustment of vertical area displayed with this projector. Press POINT LEFT/RIGHT button(s) to decrease/increase value and then press SET button. Full screen Press POINT LEFT/RIGHT button(s) to switch Full screen function to “On” or “Off. ” Set “On” to resize the image with 4 x 3 aspect ratio to fit the screen. NOTE : Fine sync, Total dots, Display area (H/V) and Full screen cannot be adjusted when “1035i (HDTV)” or “1080i (HDTV)” is selected on PC SYSTEM Menu (P22). Press SET button at Display area icon and Display area dialog box appears. Display area Press POINT LEFT /RIGHT button(s) to adjust value and then press SET button. To store adjustment data. This Mode has parameters being stored. 3 Store To store adjustment parameters, move a red frame pointer to Store icon and then press SET button. Move a red arrow pointer to any of Mode 1 to 5 that you want to store to and then press SET button. Mode free To clear adjustment parameters previously set, move a red frame pointer to Mode free icon and then SET button. Move a red arrow pointer to the Mode that you want to clear and then press SET button. Reset Reset all adjust parameters on adjustment dialog box to previous figure. [. . . ] When connecting the Macintosh computer, MAC Adapter (not supplied) is required. Pin Configuration 5 10 15 14 4 9 3 8 13 2 7 12 1 6 11 1 2 3 4 5 6 7 8 Red Input Green Input Blue Input Sense 2 Ground (Horiz. sync. ) Ground (Red) Ground (Green) Ground (Blue) 9 10 11 12 13 14 15 +5V Power Ground (Vert. sync. ) Sense 0 DDC Data Horiz. DDC Clock RGB INPUT TERMINAL (DIGITAL) Terminal : DVI 24-pin Connect the display output terminal of the computer to this terminal with DVI cable (for Single Link T. M. D. S. Pin Configuration 1 2 3 4 5 6 7 8 T. M. D. S. [. . . ]