User manual CANON LV-7365 LV USER'S MANUAL

[. . . ] MULTIMEDIA PROJECTOR LV-7365/LV-7265/LV-7260/LV-X7 User's Manual The LV-7365 projector's model name indicated on the projector's label is LV-7365 and LV-7365 (E) respectively. Both models are referred to as LV-7365 throughout the user's manual except some of the specifications pages. English E Important Information Safety Cautions Precautions Please read this manual carefully before using your Canon LV-7365/LV-7265/LV-7260/LV-X7 projector and keep the manual handy for future reference. Your serial number is located on the bottom of your projector. Record it here: CAUTION To turn off main power, be sure to remove the plug from power outlet. [. . . ] MENU INPUT AUTO PC IMAGE INPUT AUTO PC ASPECT NO SHOW KEYSTONE VOL - MENU LAMP VOL + BACK 2. Press the OK button or press the POWERbutton again. ThePOWERindicatorwillgloworange. Aftertheprojector turns off, the cooling fans keep operating for 30seconds(Cooling-offtime). Immediately after turning on the projector and displaying an image, you cannot turn off the projector for60seconds. TurnofftheMainPowerswitch. Thepowerindicator willgoout. TIP: The main power of the projector can be turned off by pressing the main power switch or by unplugging the power cord even during the cool down period after the projector is turned off. NOTE: Do not turn off the main power within 10 seconds of making adjustment or setting changes and closing the menu. Doing so can cause loss of adjustments and settings. Power On WARNING Fan running WARNING Standby WARNING LAMP LAMP LAMP Steady green light Blinking orange light Steady orange light CAUTION: Parts of the projector will become heated during operation. Use caution when picking up the projector immediately after it has been operating. CAUTION: · The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indicator is blinking green. Doing so could cause premature lamp failure. · Do not turn off the AC power by pressing the main power switch or by unplugging the power cord when the projector is powered on. Doing so can cause damage to the projector. 32 3. Projecting an Image (Basic Operation) After Use Preparation: Make sure that the projector is turned off. Puttheprojectoranditsaccessoriesinthesuppliedsoftcase. Place the projector in the soft case with the lens facing upward as shown below. this is to prevent the lens from damage. insert the projector with the lens facing upward NOTE: When placing the projector in the soft case, retract the tilt feet and the rear feet. Failure to do so may case damage to the projector. CAUTION: Use caution when putting the projector in the soft case immediately after the projector has been operating. The projector cabinet is hot. 33 4. Convenient Features Turning off the Image and Sound Press the NO SHOW button to turn off the image and sound for a short period of time. Press again to restore the image and sound. POWER INFO. IMAGE INPUT AUTO PC ASPECT MENU NO SHOW BACK Freezing a Picture Press the FREEZE button to freeze a projected moving picture such as DVD. Press again to resume motion. L-CLICK R-CLICK VOL PAGE D. ZOOM FREEZE Enlarging and Moving a Picture You can enlarge the picture up to 400 percent. NOTE: The maximum magnification may be less than four times depending on the signal. [. . . ] Batteries are new and are not reversed in installation. If present on the remote control, projector selector switch is not used. Buttons on the projector cabinet do not work ( only models with the Key lock function). Key lock is not turned on or is disabled in the menu. [. . . ]