User manual CANON MICROFILM SCANNER 400

[. . . ] ENGLISH Be sure to read this instructions before you use the equipment. Keep this instructions on hand for reference to ensure optimum preformance. FCC REGULATIONS (For 120V models) This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] On the front of the main unit, locate the power switch on the lower left corner then press the I side of the switch to turn the power on. Turn on the power switch of the printer. After you turn the unit on, the Print display starts to blink and will continue to blink while the unit warms up. While the Print display is blinking, you cannot start operation. When the Print display stops blinking and stays on, the unit is ready for normal operation. To turn the unit off, press the O side of the power switch. Setting the film Load the auto carrier with the film you want to view. For details about the auto carrier installation, see the instructions you received with the auto carrier. 14 OPERATING PROCEDURES Adjusting the image Follow the procedure below to adjust the image on the screen. Read and perform this procedure correctly to attain a crisp image on the screen and a clear printed copy. Rotating the image 1 2 3 To rotate the image to the desired angle, rotate the rotation fin 1 to the left or right. Enlarging and reducing image size To make the image larger or smaller, rotate the zooming fin 2 on the lens to the left or right. Focusing the image To focus the image on the screen, rotate the focusing fin 3 on the lens to the left or right. 15 OPERATING PROCEDURES Printing The image on the screen can be printed with a printer connected to the unit. This section describes how to set the film mode and execute a print. Starting a print 1. Check the main unit and the printer and make sure that they are both turned on. (The power switches should be set to the I position. ) You can execute a print after both the main unit and printer have warmed up. The main unit is warmed up when the Print display on the operation panel comes on and stops blinking. Select a positive or negative type film. Press the Negative/Positive key to select a film mode. The lamp to the left of the key and icons tells you the current selection. Press the key and keep pressing it until the lamp next to the selection you want lights. Negative Positive Auto Prints positive on negative film. Automatically detects the type of film in use and prints a positive image. If you select Auto, the Negative or Positive lamp blinks to tell you which type of film has been detected. The EZ-04 zoom lens has no function to automatically switch between Negative and Positive. When using the EZ-04 zoom lens, always use the Negative/Positive switching key to select ( ) negative or ( ) positive. Do not use Auto for an image with a grey or light border (where black and white may be difficult to distinguish), or if you intend to remove the border from the image, trim the image, or define the area on the image with the other keys. If you intend to use these special functions, set Negative or Positive manually. [. . . ] If the message appears again, replace the toner cartridge. For details, refer to the printer manual. Close the printer cover and make sure it locks in place. Check the lamp installation and make sure it is installed correctly. [. . . ]