User manual CANON PC5 BROCHURE

[. . . ] € If you attach two battery packs, they are charged one following the other (i. In this case, a red charge indicator shows the progress of charging for the battery pack that you attached first. (Or for the battery pack attached to the side labelled A, if you attached both before plugging the adapter into a household power socket. ) When the indicator starts to glow steadily (the first battery is fully charged), the second charge indicator shows the progress of charging for the other battery pack. [. . . ] € The adapter can be used with a power supply between 100 and 240 V AC. Contact your Canon dealer for information about plug adapters for overseas use. € To prevent equipment breakdowns and excessive heating, do not connect this adapter to voltage converters used by travelers, or special power sources such as on aircraft, ships or DC to AC inverters, etc. € Use only specified products with this adapter. € You can only use the BP-400 Series Battery Packs with this adapter. € Do not disassemble the adapter, do not get it wet, and do not expose it to shock or vibration, or to direct sunlight. Avoid exposure to high temperatures, such as in a closed car in hot weather, and do not leave it near heat–radiating equipment, such as a stove or heater. 5A DC Operating temperature range: 0°– 40°C (32°– 104°F) Dimensions: 75 × 120 × 53 mm (3 × 4 3 /4 × 2 1/8 in) Weight: 250 g (8 7/8 oz) (without power cable) Weight and dimensions are approximate. When the replacement of power supply is required, please return it to the responsible nearest Canon Service Center, and please replace it with the same type number CA-400 or equivalent. Box 2262, 1180 EG Amstelveen, the Netherlands PUB. For Users in the USA FCC NOTICE This device complies with Part 15 of the FCC Rules. If the product has been exposed to rain or water. If the product does not operate normally even if you follow the operating instructions. Adjust only those controls that are covered by the operation instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. If the product has been dropped or the cabinet has been damaged. Replacement Parts – When replacement parts are required, be sure the service technician has used replacement parts that are specified by Canon or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. Safety Check – Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in safe operating order. nEC - NATIONAL ELECTRICAL CODE ELECTRIC SERVICE EQUIPMENT GROUND CLAMP Important Warning CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN 1. Read Instructions – All the safety and operating instructions should be read before the product is operated. Retain Instructions – The safety and operating instructions should be retained for future reference. [. . . ] Do not defeat the safety purpose of the polarized plug. Power Cord Protection – Power cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to plugs and the point from which the cords exit the product. Outdoor Antenna Grounding – If an outside antenna is connected to the product, be sure the antenna is grounded so as to provide some protection against voltage surges and built-up static charges. [. . . ]