User manual CANON PIXMA IP3300

[. . . ] Open the Front Feeder and extend the Output Paper Support. 2 Install the Print Head d Open the Top Cover. The Print Head Holder moves to the center. Top Cover 3 Install the Ink Tanks a Peel back the orange tab completely and remove the plastic wrapper from the ink tank. a Remove the Print Head from its package. Loading Paper This printer offers two paper sources to load printing paper; the Auto Sheet Feeder, found at the top of the printer, and the Front Feeder, found at the front of the printer. Caution Before turning on the printer, remove all of the shipping tapes. Important Do not connect the USB cable until after the software is installed. [. . . ] · Before installing the driver, disable all anti-virus programs and automatically loading programs. f Read the License Agreement carefully and click Yes. M ac in to sh w s Follow the on-screen instructions to install the software. If a message asking for your confirmation to restart your computer appears, click OK. the printer with a USB cable, then turn the printer on. The software will begin identifying the printer port being used. Important If you cannot go to the next procedure after 2 minutes, refer to "Troubleshooting" instructions in the User's Guide on-screen manual. Important Since Mac® OS 9, Mac OS X Classic environments, or Mac OS X v. 10. 2. 7 or earlier are not supported, do not connect the printer to these. Note · Use Mac OS X v. 10. 2. 8 to 10. 4. x. · The screens below refer to Mac OS X v. 10. 4. x installation. Screens may vary depending on the operating system you are using. · Log on as an Administrator before continuing. · Before installing the driver, disable all anti-virus programs and automatically loading programs. g When the list of applications to install appears, confirm the contents, then click Install. Note Move the cursor over items to display explanations of each application below. g When the Printer Connection screen appears, connect h Read the License Agreement carefully and click Yes. a Turn off the printer. (1) Press the POWER button. (2) Make sure that the POWER lamp stops flashing. Follow the on-screen instructions to install the software. Note When the User Registration screen appears, follow on-screen instructions to register your product. You will need your product serial number, which is located on the inside of the printer. See Step 1- e on the front page. i Follow the on-screen instructions to register your product. b Turn the computer on and start Windows. Important If you see the Found New Hardware Wizard, remove the USB cable. Then proceed from step 3 to install the printer driver. a Connect one end of the USB cable to the computer, the other to the printer. Note Make sure the printer is turned on. j When the Installation completed successfully screen appears, click Restart. The system is restarted automatically. c Insert the Setup CD-ROM. The setup program should run automatically. Note The setup program should run automatically. [. . . ] "Windows" is a trademark of Microsoft Corporation, registered in the United States and other countries. "Macintosh" and "Mac" are trademarks of Apple Computer, Inc. , registered in the U. S. "Adobe" and "Adobe RGB (1998)" are either registered trademarks or trademarks of Adobe Systems Incorporated in the United States and/or other countries. [. . . ]