User manual CANON PIXMA MX700

[. . . ] Be careful not to get ink on yourself when handling these items. Electrical Contacts c Remove the orange protective cap from the Print Head and discard it. Important · Do not touch the electrical contacts. · Do not touch the ink port. Important Once you have installed the Print head and ink tanks, wait about two minutes until the message "Perform head alignment in the case colors or lines are off. " appears, then press the OK button. The Copy standby screen appears on the LCD. Front Tray Loading Paper in the Rear Tray a oad the paper in the Rear Tray with L the print side facing UP. c Insert the ink tank into the right-hand Caution Before turning on the machine, remove all of the shipping tapes. Important If an unintended language is displayed on the LCD, press the Back button on the Operation Panel to return to the Language selection screen. Electrical Contacts slot and press the mark on the ink tank until it clicks into place. [. . . ] · Do NOT connect the USB cable at this stage. Important Be sure that the Print Head Lock Lever is pressed all the way down, and that the Print Head is locked firmly in place. If the Print Head is tilted forward, or the Print Head Lock Lever is pressed only halfway down, raise the Print Head Lock Lever and remove the Print Head, and then reinstall the Print Head. Paper Size Mark Note For details, refer to the Quick Start Guide. USB connection is explained here. For wired LAN connection, refer to the Network Setup Guide. Windows® Software Installation w s g When the list of applications to install appears, confirm the contents, then click Install. Note Move the cursor over items to display explanations of each application. Macintosh® Software Installation sh i When the User Registration screen appears, click Next. Note To register later, click Cancel and go to Step j. After software installation is complete, double-click on the desktop. do W in h Read the License Agreement carefully and click Yes. The · · · · Note The screens below refer to Windows VistaTM operating system Ultimate Edition (hereafter referred to as "Windows Vista") installation. Screens may vary depending on the operating system you are using. Log into a user account with the administrator privilege. Before installing the software, disable all anti-virus programs and automatically loading programs. A message asking for your confirmation to restart your computer may appear during the installation process. If this message is displayed, follow the on-screen instructions and click OK. The installation resumes from where it left off when your computer has been restarted. M ac in to software installation screen may appear during the installation process. Follow the on-screen instructions to install the software. printer via USB, then click Next. · · · · i When the Setup Method screen appears, select Use the Note Since Mac® OS 9, Mac OS X Classic environments, or Mac OS X v. 10. 2. 7 or earlier are not supported, do not connect the machine to these. The screens below refer to Mac OS X v. 10. 4. x installation. Screens may vary depending on the operating system you are using. Before installing the software, disable all anti-virus programs and automatically loading programs. Follow on-screen instructions to register your product. You will need your product serial number, which is located on the inside of the machine. See Step 1- h on the front page. j When the Installation completed successfully screen appears, click Restart. a Connect one end of the USB cable to the computer and the other to the machine. Note Make sure the machine is turned on. a Be sure to TURN THE MACHINE OFF before continuing. (1) Press the ON/OFF button. [. . . ] You cannot send faxes from your computer via the machine. USB b Turn on your Mac and insert the Setup CD-ROM. The setup program should run automatically. In Windows Vista, go to Step d. In Windows XP and Windows 2000, go to Step f. USB To Computer k When the Setup Complete screen appears, click Next. Note If the CD-ROM folder does not open automatically, double-click the CD-ROM icon on the desktop. c Double-click the Setup icon. d When the Authenticate screen appears, enter your administrator name and password. [. . . ]