User manual CANON PIXMA MG3222

[. . . ] Please read these guides. Bad example: Tank 6BK is not fully inserted. Make sure to press it down firmly. 3 Close the Inner Covers and the Scanning Unit. Click · In this sheet, illustrations of MP780 are shown. · A printer cable is not included. [. . . ] (MP780 model only) Connect the telephone line and any necessary external device. Connect external devices as follows: External device jack Telephone line jack Close the two Inner Covers. Pull the Scanning Unit Lever towards you to close the Scanning Unit. IMPORTANT Be sure to hold the Scanning Unit firmly with one hand. 6 Load the paper. 1 2 Open the Auto Sheet Feeder. Load two sheets or more of letter-size plain paper. (1) Open the Auto Sheet Feeder. Load the paper with the print side face up. Pinch and adjust the paper guide to the width of the stack. Telephone or answering machine Telephone line Machine Telephone or answering machine Connect the telephone line cord to the wall jack. You can connect an external device (telephone or answering machine) if necessary. Built-in computer modem and telephone Telephone line Machine LINE TEL Computer Telephone 3 Connect the power cord. 1 2 Connect the power cord. 1. Connect one end of the power cord to the rear of the machine. Connect the other end to the AC outlet. (2) Pull out the Paper Support until it stops. Ensure the paper stack does not exceed the paper limit mark. 7 Align the print head from the Operation Panel. Be sure to align the print head to ensure print quality. If the message <PUT IN CARTRIDGE> appears, go to Step 4, "Install the print head. " 1 Press [OK] to start print head alignment. (2) Press [OK]. MP Drivers Easy-WebPrint MP Navigator ScanSoft OmniPage SE Step 2: Prepare the Setup CD-ROM. 1 Turn ON your computer, and start Mac OS X. 2 Insert the Setup CD-ROM into the CD-ROM drive. 3 Double-click [Setup] on the Setup CD-ROM, or click [Setup] on the Setup CDROM and click [File] menu and then select [Open]. Step 1: Prepare the Setup CD-ROM and Get Ready to Install. 1 Turn ON your computer, and start Windows. 2 Insert the Setup CD-ROM into the CD-ROM drive. · The setup program should automatically run. If the setup program does not automatically run, click [My Computer], then double-click [setup] on the Setup CD-ROM. IMPORTANT If the following screen appears, the USB cable is connected. Step 3: Enter the name and password for an Administrator Account. 2 Enter the password and then click [OK]. Enter Click Perform the following steps. 1. [. . . ] 1 Click [Easy Install], then click [Install]. · To read descriptions of the software programs, click the · To read restrictions of the software programs, click the icon. 1 Click [Easy Install], then click [Install]. · To read descriptions of the software programs, click the · To read restrictions of the software programs, click the icon. icon. Click Click Click 2 Click [Yes]. · Installation begins. 3 Click [Continue]. · Follow the displayed instructions. Click 2 Click [Yes]. · Installation begins. 3 Click [Continue]. · Follow the displayed instructions. [. . . ]