User manual CANTON CD 3500 WIRELESS

[. . . ] Holidays), remove the mains plug from the socket or turn the loudspeaker off at the mains switch. Your CD 3500 wireless can be completely isolated from the mains electricity by the mains switch because it uses a double-pole configuration. In this mode, your CD 3500 wireless does not use any electricity. To avoid damage from lightening strikes, the mains plug should also be unplugged when thunderstorms are expected. [. . . ] Please be careful not to swap over the channels, right = red and left = black. If your audio source is equipped with loudspeaker outputs, connect Ist Ihr Steuergerät nur mit Lautsprecherausgängen versehen, verbinden Sie diese mit den Schraubklemmen des Tranceivers. The transceiver can then be connected to the mains power supply and your control unit can be switched on. These to the screw terminals on the transceiver. As well as checking the correct channel connections, make sure the cabling polarity is correct. To avoid shortcircuiting, the stripped ends of the loudspeaker cables should be as short as possible, not protrude out of the screw terminals and under no circumstances should they be touching. The only cabling for both CD 3500 wireless loudspeakers involves mains connection. 6) to , , on" and your loudspeakers are ready to use. Introducing a music signal will activate the system out of standby mode. This allows you to regulate the sound level evenly for the left and right channels. As a basic principle for audio sources with variable output, the sound level should preferably be set high and the reproduction sound levels should be regulated via the remote control. the infrared sensors for receiving the remote control signal are located in the transceiver and in the loudspeakers. This means that the sound can be controlled by remote control even when the speakers are placed in an adjoining room without line of sight to the transceiver. When the system is switched off, the most recent volume settings are retained. Setting the sensitivity of the transceiver depends on the audio source that is being used. 16) on the back of the transceiver can be used to align the sensitivity of the transmitter module to the volume level of your control unit. Settings between P 1 and P 3 are available whereby P 1 is the highest level of sensitivity. If the selected input sensitivity is too high, the transceiver becomes overloaded, the sound from the loudspeakers is distorted and the LEDs of the function indicator (Fig. When the correct input sensitivity has been chosen, the LEDs on the function display glow green or briefly flash orange at extreme levels. For example, if P 1 is the switch setting on the transceiver, then P 1 must also be selected on the loudspeakers. The CD 3500 wireless can be connected like a normal active loudspeaker directly via an appropriate cable by using the screw terminals (Fig. Adjusting the volume level is done via the variable output on your control unit and NOT via the enclosed wireless system remote control. [. . . ] Loudspeakers are badly placed ­ change their position. No sound signal, LEDs on transceiver flash green No sound signal, LEDs on transceiver glow permanently green System switches off during quiet music Sound signal distorted, LEDs on transceiver glow orange 3" Brushed aluminum silver up to 25 meters in closed environments max. WARRANTY Canton provides a 5 year warranty against factory defects for all passive loudspeakers. There is a 2 year warranty against factory defects for active subwoofers and semi-active speakers. [. . . ]