User manual CANTON COMBI CD 2

[. . . ] If the temperature inside the unit rises, it may cause fire, damage to the unit and/or personal injury. Please place the subwoofer at a safe distance to your TV set (min. Please do not place any fragile objects on top or in front of the subwoofer. Vibrations may break the object and may cause personal injury. [. . . ] Wallmounting For the mini-speakers of the subwoofer satellite system you receive suitable wall brackets for the assembly to the wall. These wall brackets always belong to the scope of supply of your sub-sat system. You can buy the Canton LS-speaker stands as an accessory from your nearest Canton dealer. Switch-off your amplifier before connecting the speakers to it. You will find the connector terminal as shown left on the rear of your Canton speakers. These terminals are provided for connecting the Canton speakers to the amplifier. If present, first remove the insulating protective caps from the screw terminals. In order to make it easier to distinguish plus (+) from minus (-) the clamps on the back of the loudspeaker (plus = red, minus = black) as well as the screwclamps of your amplifier or receiver differ in colour or are marked with a symbol. also the two conductors of the loudspeaker cable differ in colour , form or marking. Different polarity between the left and the right or the front and the surround channel lead to sound falsifications. For a better understanding please check the operating instructions of your controller. Screw terminals: For connections to the loudspeaker outputs on your amplifier, the Canton active subwoofer is fitted with two sets of screw terminals marked HIGH LEVEL INPUT (fig. When connecting, please note the correct layout of the left and right ports and the polarity of the terminals (red = plus / black = minus). If the polarity is accidentally reversed, the sound from the subwoofer will be unnatural with poor bass. RCA sockets: The Cinch inputs on your subwoofer are marked LOW LEVEL INPUT and are designed for connection to a preamplifier output or a special subwoofer output (LFE) on your control unit (fig. In case of using the included wires the RCA sockets remain unused. To cut the power, switch the subwoofer off using the power switch (fig. When the subwoofer is in use the LED is green. amplifier Mode: When the power switch is set to "ON" , the Amplifier Mode switch (fig. 7) can be used to select from two operating modes. In the "AUTO" position, the subwoofer automatically switches itself on when a musical signal is detected. In the absence of any musical signal your subwoofer automatically (approx. [. . . ] If the hum disappears when a particular device is switched off, get it fitted with interference suppression, or try connecting it to a different phase line of the supply mains (consult an electrician if necessary). This filter is available from your dealer. 6 Is the signal level setting at the amplifier (volume) too low ?8 Is the output level at the amplifier set too low for the subwoofer output (Cinch output) ? [. . . ]