User manual CANTON DIGITAL MOVIE DM 90

[. . . ] Die Adressen der internationalen Canton-Vertriebspartner finden Sie unter: The addresses of Canton's international distributors can be found at: Please read these operating instructions carefully and keep them for reference. Canton cannot be held liable for any damage resulting from non-compliance with the following instructions. Choose a level, dry and clean place for your speakers, away from windows with direct sunlight, heat sources, vibrations, high humidity and extreme cold. Contact your authorized dealer or a qualified repair specialist in the event of problems or defects. [. . . ] Note: The functions of the < select > keys are only activated when at least one additional device has been logged on and/or programmed by you in addition to the DM system already logged on. You will find more information on this on Page 58. The volume of the DM system can be regulated in 100 increments from 0. If you want to switch the DM system off, press again to put the DM system into standby mode. Please note that the DM system inputs are switched over with < input > while <select> regulates the devices to be controlled remotely. You can select the following sources with tv, vcr, aux, tuner, dvd, sat : Note: To do justice to the various recording philosophies, especially with music recordings, we have implemented two surround modes. Use , , surround 2" above all when the speech is difficult to understand (e. When the voice reproduction seems to be unusually muffled and unintelligible). Use to select whether the sound is to be reproduced in the stereo or surround mode. the system sets the corresponding decode mode automatically , depending on the input signal. Stereo or PCM are activated as analog sound in the , , stereo" play mode, Virtual Dolby Digital, Virtual Dolby Pro Logic II or Virtual DTS in the , , surround 1 und surround 2 / 2. Once you have successfully connected your DM system, you should then adapt the individual components to your listening area. If you want to adjust the settings of your DM system, please switch it on and select Speaker Setup or Parameter Setup by pressing the MENU key once or twice respectively. This will not work if the tuner has been selected as the source device. Begin by measuring the distance between the individual components of the DM system and your preferred listening position (in line with the Distance Setup graphs). enter these values in the menu at the corresponding speaker (Subwoofer , Front Left , Front Right) under `Distance'. Is used to adjust the volume of the DM components among one another. The volume of the satellites and central surround should be the same at the listening position. Their , , Distance" setting can not be changed. The following parameters can be selected with You can determine under Output whether the lower pre-amplifier output on the back of the subwoofer is switched as Line Out (fixed volume level for an analog recording device - only DM 1 and DM 2) or as Zone 2 (adjustable volume for an active multi-room system or wireless loudspeaker system, for example). Instead of Line Out appears Subwoofer with the DM 90. this makes the connection of an additional active subwoofer possible. [. . . ] Raise the bass level in the transfer area as described in , , room comp function bass" (p. Raise the bass level in the transfer area as described in , , room comp function bass" (p. Too much treble Not enough top bass The subwoofer is very close to a wall or corner Lower the bass level in the transfer area as described in , , room comp function bass" (p. Reposition the sub farther away from the wall Too much bottom bass The subwoofer is very close to a wall or corner 2. [. . . ]