User manual CANTON HIFI + HOME CINEMA

[. . . ] For decoupling the speakers from the floor most Canton speakers are provided with self-adhesive rubber pucks. The damping pucks can be stuck underneath the speakers. If there are tapped holes provided in the bottom of your Canton speaker use them for attaching the metal spikes. most of the Canton compact speakers can be mounted to the wall. [. . . ] For further information please consult the operating instructions manual of your A/V amplifier (surround amplifier, receiver). Wallmounting For most of the Canton mini-speakers wall brackets are available. these make it possible to place the speakers in optimum earlevel position. With some Canton mini-speakers the wall brackets are included. If not you can buy them as a Cantomount wallbracket from your authorized Canton dealer. You can buy the Canton LS-speakerstands as an accessorie from your nearest Canton dealer. Positioning a center-speaker The prefered place for a center-speaker is above or below your television set. For optimizing the dispersion-angle some Canton mini-centers are equiped with a stabilisator. By tuning the stabilisator you can adjust its hight and therewith the dispersion-angle of the center-speaker. Switch-off your amplifier before connecting the speakers to it. You will find one of the connector terminals as shown left on the rear of your Canton speakers. These terminals are provided for connecting the Canton speakers to the amplifier. If present, first remove the insulating protective caps from the screw terminals. In order to make it easier to distinguish plus (+) from minus (-) the screwclamps on the back of the loudspeaker (plus = red, minus = black) as well as the screwclamps of your amplifier or receiver differ in colour or are marked with a symbol. also the two conductors of the loudspeaker cable differ in colour , form or marking. Different polarity between the left and the right or the front and the surround channel lead to sound falsifications. For a better understanding please check the operating instructions of your controller and the possibly used subwoofer. Most of our speakers are equipped such that you can connect the tweeter/midrange chassis and the woofer chassis separately to two respective amplifiers (bi-amping), or at least via two separate connecting cables (biwiring). [. . . ] In this time the characteristics of all mechanical parts change until they reach the values specified during the development of the loudspeaker, i. WARRANTY Canton provides a 5 year warranty against factory defects for all passive loudspeakers. There is a 2 year warranty against factory defects for active subwoofers and semi-active speakers. The warranty period starts with the purchase and applies only to the first purchaser. [. . . ]