User manual CARDO SCALA RIDER Q2 MULTISET

[. . . ] TM Q2 MultiSet TM communication in motion TM User Guide Gebrauchsanleitung Guide d'Utilisation Guida di Avvio Guia de Usario © Cardo Systems, Inc. The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Cardo Systems, Inc. Other trademarks and trade names are those of their respective owners. 2 scala rider® Q2TM MultiSet INTRODUCTION Congratulations and thank you for choosing the scala rider Q2 MultiSet Bluetooth® Headset package for bikers. [. . . ] Manual Connect Intercom can be initiated from either headset. Failed Connection: On the scala rider Q2, if you attempt to start a Buddy Intercom call with a Buddy that is already on a Phone/GPS/ Intercom call, you will hear a double beep indicating the Buddy is busy. scala rider® Q2TM MultiSet 9 Reconnecting the Intercom: If the scala rider Q2 and its Intercom Buddy headset go out of range and disconnect from each other, the scala rider Q2 will automatically try to reconnect to its Intercom Buddy for five minutes. You can manually reconnect at any time by pressing the MC Button (single tap for Primary Buddy and double tap for Secondary Buddy). Receiving Intercom calls If you are not speaking with any one, once the other party tries to initiate a Buddy Intercom call, the call will begin immediately. TROUBLESHOOTING THE INTERCOM: First, make sure your microphone is located properly in front of the center of your mouth. The scala rider Q2 is designed for use in loud environments. Please make sure to test the Intercom functionality in a LOUD environment, such as next to an idling motorcycle. Please also verify that the headsets were paired together properly by following the instructions in the relevant Setup sections. Press and hold the Volume Up Button for three seconds and you will hear a beep: · One beep ­ Voice Connect set to Primary Buddy · Two beeps ­ Voice Connect set to Secondary Buddy Enable/Disable Voice Connect feature Press and hold the Volume Up and Down Buttons simultaneously until you hear a beep. The default status is Voice Connect enabled. NOTE: The Enable/Disable Voice Connect feature affects the Intercom functionality only. MAKING AND RECEIVING MOBILE PHONE CALLS PHONE FUNCTIONS Answer a call Reject a call Terminate a call Voice Dial Short press the CTRL Button or speak loudly any word of your choice during an incoming call. Short press the MC Button or remain silent for 15 seconds during an incoming call. Short press the CTRL Button to end a call. During Standby, short press the CTRL Button and state the name of the person you wish to call. This feature is supported only by mobile phones that support the Voice Dial feature. Press and hold the Volume Down Button for three seconds during Standby. Setting Voice Connect Intercom preference (Primary vs. Secondary Buddy) The headset's Voice Connect feature allows you to start a Buddy Intercom call by simply speaking into the microphone. You can define which of the two Buddy headsets you wish to connect to when using Voice Connect Intercom. NOTE: The Primary Buddy has priority by default. To toggle the Voice Connect Intercom between Primary and Secondary Buddy: 10 scala rider® Q2TM MultiSet Redial NOTE: If your Bluetooth mobile phone is paired to a Bluetooth GPS device, not directly to the scala rider Q2, some of the above Phone functions may not be compatible. When the headset is on an active phone call, any Buddy Intercom call request will be rejected automatically. Once the phone call audio link drops, you can initiate and accept Buddy Intercom calls. received, or when you decide to initiate a call. When the conversation is over, the headset automatically tunes back in to the FM Radio. Turning the FM Radio On While no call is on the headset (either mobile phone call or Intercom call), press and hold the MC Button on your headset for three seconds to turn on the radio. [. . . ] If you do not accept all terms of this agreement, you should immediately return the product for a full refund. By using the headset you agree to be bound to this agreement and forfeit the right to sue. Using a communication device while riding a motorcycle, scooter, moped, ATV, quadbike or any other vehicle or equipment, whether on land, water or air (jointly referred to as "Vehicle") requires your complete and undivided attention. Cardo Systems, Inc. , including its Officers, Directors, Affiliates, Parent Company, Representatives, Agents, Contractors, Sponsors, Employees, Suppliers and Resellers (jointly referred to as the "Company" or "Cardo") strongly advises you to take all necessary precautions and remain alert to the traffic, weather and road conditions if you choose to use the scala rider Q2 headset, including all derivative models irrespective of its commercial name or branding (the "Device"), and stop your Vehicle on the roadside prior to initiating or receiving calls. [. . . ]