User manual CARLO GAVAZZI G3800 X015 CONFIGURATION SOFTWARE

[. . . ] Du line ® Fieldbus Installationbus Configuration Software G3800 X015 User Manual Preliminary Data December 2002 G 3800 X015 Configuration Software October 2002 Table of Contents 1. Decentralized roller blind up-down function 2. 5. 2. Multiplexer (transmission of counter values) 2. 6. 2. Multiplexer (transmission of analog values) 3. [. . . ] Details can be found in the chapter describing The alarm siren/Common siren. The various Intruder alarm objects are selected under "Channel function": Passive detector: This object makes it possible to control windows, doors, etc. If the contact is activated and a "1"-Signal consequently transmitted on the Dupline bus, an alarm is started. This object makes it possible to control windows, doors, etc. When the contact is activated and a "0"-Signal consequently transmitted on the Dupline bus, an alarm is started. See the chapter describing the Toggle Switch function Active detector: Toggle switch function: Motion detector: The motion detector can also be integrated in the intruder alarm. See the chapter describing the Motion detector. 44 © 2002 Carlo Gavazzi Industri A/S. All rights reserved G 3800 X015 Configuration Software October 2002 Manual armouring: This object makes it possible to include a push button to enable and reset the alarm. The object only enables the alarm contacts for which no or a deactivated disable address has been entered. Manual armouring thus partly enables alarms. Upon activation of manual armouring, the armouring delay begins to run. During this time, the channel generator ignores activated alarm contacts. If subsequently an enabled alarm contact is activated, this channel begins to flash and triggers off an alarm through the siren after elapse of the de-armouring delay. To acknowledge the alarm, press the manual armouring key once. To restart the alarm system, press twice. This object makes it possible to include a switch to activate the alarm system. The function is similar to that of the manual armouring, only in door lock armouring the disable addresses entered at the alarm contacts are ignored. This means that the switch performs total enabling. Upon activation of the switch, the armouring delay begins to run. During this time, the channel generator ignores activated alarm contacts. If subsequently an alarm contact is activated, this channel (like manual armouring) begins to flash and triggers off an alarm through the siren after elapse of the de-armouring delay. The alarm is acknowledged by switching off the door-lock armouring. [. . . ] The central MGEN must be defined for "Radio Modem central" function for COM2, while the remote MGEN's must be defined as "Radio modem substation". The central MGEN can be configured for the usual intelligent functions, and it can also be connected via COM1 or the RS485 port to a PLC or PC. The remote MGEN's, however, cannot be configured for any intelligent function. They will simply operate as Radio Modem interfaces. [. . . ]