User manual CARLSBRO COLT 40

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 2. Control panel at your orders (p. 2) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. 3. How to load your dishes (p. 3) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 4. How to start your dishwasher (p. [. . . ] The rinse aid container is situated on the inside of the door: It should be filled up when the low rinse aid indicator light "T" flashes. To obtain the best results from each washing and drying cycle, powder detergent, rinse aid liquid and salt should be used. Loading the rinse aid. To open the dispenser, turn cap C anticlockwise. Take care when you pour in the rinse aid to avoid it overflowing. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. You can choose from six different positions. You can choose from six different positions. It is normally set to 4. Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. Economic and fast cycle Wash at 48°C to be used for slightly Hot rinse at 67°C dirty dishes. Preliminary wash cycle for dishes while the load is awaiting completion with the dishes from the next meal. Special cycle to be used for more delicate items which are sensitive to high temperatures. If it takes quite some time to fill up your dishwasher, use the soak cycle to avoid the formation of bad odours and caked-on food. Select the most suitable wash cycle for the type of load you have placed in the dishwasher. The choice of wash cycle depends on the type of dishes to wash and on how dirty they are. To select the right wash cycle, please consult the wash cycle table on page 6. I Silver plates and serving dishes should be washed immediately after use, especially if they have contained salt, eggs, olives, mustard, vinegar, fruit juices and cooked vegetables. I For particularly delicate dishes, we recommend you use the specific wash cycle offered by your dishwasher. ARISTON DISHWASHER - Instructions for installation and use % D 1509)50-4 Installation and moving Choose where you want to install your dishwasher, you can even place it so that its sides or back panel are side by side with furniture or up against the wall. The dishwasher is provided with water supply and drain hoses, which can be directed towards the left or right to facilitate appropriate installation. This dishwasher model can be built under a single worktop (please read the relevant instruction sheet). Your dishwasher has arrived Hot water connection. Your dishwasher can be supplied with hot water from the mains supply (if you have a central heating system with radiators) at a temperature of no more than 60°C. In this case, the wash cycle time will be about 15 minutes shorter and the wash will be slightly less effective. The connection must be made to hot water supply following the same procedures as those indicated for the cold water connection. Fit the drain pipe into a drain line with a minimum diameter of 4 cm or place it over the sink. [. . . ] The filters remove food residue from the water used in the wash cycle: to obtain the best results from each wash, they should be cleaned. After cleaning check that the filter assembly has been replaced correctly. The dishwasher should not be used without filters or when the filter is loose. C Keep your dishwasher in shape Respecting these few rules ensures you will always have a reliable work companion by your side. After every wash. When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. [. . . ]