User manual CARLSBRO EQUALIZIER

[. . . ] Humbuckers (dual coil pickups) generally have higher output than singlecoil pickups, and tend to overdrive more easily. Singlecoils usually have a brighter, `clearer' tone but less body to the sound. In addition, a pickup sounds tighter and more crisp closer to the bridge and has a warmer, more rounded sound closer to the neck. TECHNICAL SPECIFICATIONS: Voltage Requirement For 230V the working range is 207V to 253V 50-60Hz For 115V the working range is 104V to 126V 50-60Hz Power Consumption 40VA Power Output 25W RMS Output (8W) Dimensions: Height - 355mm Width - 320mm Depth - 210mm Weight (Approx) - 6. 2Kg Carlsbro Electronics Limited constantly seek ways to enhance our products, and improvements take place continually. [. . . ] Correctly used it will provide years of reliable service and fulfill all you performance needs. Please read this user guide thoroughly in order to safeguard your equipment and to obtain maximum performance from it. The Kickstart range have been designed and voiced specifically with the beginner guitarist in mind. They have been designed to be intuitive and simple to use to enable anyone to start playing with the minimum of fuss, but have enough quality and features to keep you playing for years to come. They are ideally suited for home practice, producing a versatile range of tones without excess volume. UNPACKING AND INSPECTION Carefully unpack the unit. If it appears damaged in any way, return it to the retailer it was purchased from in its original packaging. Carlsbro Electronics Ltd cannot accept any responsibility for damage arising from the use of non-approved packaging Jazz: SYSTEM CONTENTS 1. Country: Kickstart 25 Amp IEC Lead Manual Guarantee Card Rock/Metal Lead: Blues: MAIN FEATURES: > > > > > > > 25W output Twin switchable channels with independent gain settings Boost setting to give extra 'crunch'. British designed 8" Powertone speaker 3 band passive EQ Spring reverb Footswichable channel change and FX on/off (2-way latching footswitch sold separately) > Headphone socket > External audio input Note: Reverb and volume should be set to suit playing environment on all these suggested setting. TOP PANEL FEATURES 35 11 13 13. Clean Gain: Adjusts the gain applied to the signal when in clean mode. Use this to balance volumes when switching channels. Channel Switch: `Clean' mode is enabled with the switch out. When pushed in, `lead' mode is enabled. The switch must be out to use a footswitch. Channel Indicator LED: Will illuminate to show when the lead channel is active 5. Lead Gain: Controls the amount of gain added to the lead channel Adding gain causes harmonic distortion of the signal, producing a fuller, crunchier sound for use in rock music. Boost Switch: When pushed in, this adds a gain boost to the lead channel. This gives an extra bit of drive to the sound. Bass: This is used to control the level of bass or low frequency sound. [. . . ] Turn clockwise for boost, anti-clockwise for cut. Mid: As with bass control but offers mid boost or scoop. Treble: As with bass control but for treble or high frequencies 10. Reverb: Short for `reverberation. ' Adds an echoing character to the sound to simulate an acoustic environment. [. . . ]