User manual CARLSBRO SPEAKEASY

[. . . ] Correctly used it will provide years of reliable service and fulfill all your performance needs. Please read this user guide thoroughly in order to safeguard your equipment and to obtain maximum performance from it. The Black Box has been designed and voiced to be an versatile and compact sound reinforcement system. [. . . ] It is ideal for a wide variety of sound reinforcement applications including keyboards and electric organs, home recording, PC's and gaming, and home theatre. UNPACKING AND INSPECTION Carefully unpack the unit. If it appears damaged in any way, return it to the retailer it was purchased from in its original packaging. Carlsbro Electronics Ltd cannot accept any responsibility for damage arising from the use of non-approved packaging SYSTEM CONTENTS > > > > > > > Black Box Subwoofer 2 x Satellite Speakers 2 x Speaker wires Audio Signal Cable Mains Power Cable Manual Guarantee Card Note ; ensure the mounting point is secure, and of adequate strength to support the speaker. The satellite speakers can be positioned as desired, but stereo image will be improved if they are a few feet apart, and on the same level. To connect the satellite speakers to the subwoofer, use to speaker wire included and connect the speaker to the left (as you look at it) to the left speaker outputs on the Subwoofer, making sure that the wire connected to the red terminal is connected to the red terminal on the satellite speaker, Now connect the other wire in the same cable to the black connectors on both units. Now repeat this procedure for the right channel. LEFT SATELLITE L R RIGHT SATELLITE MAIN FEATURES: > > > > > > Phono, Mini Jack (3. 5mm) and ¼" Jack main inputs 2 x microphone inputs Digital Echo Master volume control Balance control Powerful active two band Eq SUB The speaker grilles on the front of the satellite speakers are removable. Should you wish to do this gently pull the grille away from the main body of the speaker until the grille is fully removed. FRONT PANEL FEATURES: 1 2 3 4 5 1. Use this socket only if you want to connect a mono signal to your system. Right Jack (1/4") Input: When this connection is used the unit changes from mono operation to stereo when used in conjunction with the left jack input (3) 14. Mains Switch: This turns the AC mains power to the unit on or off. NOTE: The unit is not isolated from the mains supply until the power cord is removed. IEC Input Socket: Connect the supplied IEC mains lead here. Fuse Holder: Should the mains fuse need replacing, remove the AC power lead from the supply, unscrew the fuse holder and remove the fuse. Always replace the fuse with the same type and rating printed on the rear panel of your amp. If the replacement fuse blows immediately then contact your local service agent. [. . . ] If the replacement fuse blows immediately then contact your local service agent. NOTE: ALWAYS DISCONNECT THE UNIT FROM THE MAINS SUPPLY BEFORE CHANGING THE FUSE. 15 6 7 8 9 6. MIC2: This is an unbalanced high impedance ¼" jack input suitable for microphones. [. . . ]