User manual CARVER 2585 MONTEREY

[. . . ] SELLS ITS PRODUCTS IN COMPLIANCE WITH APPLICABLE LAWS AND REGULATIONS. BECAUSE OUR PRODUCTS MAY BE SOLD IN THESE STATES, WE INCLUDE THE FOLLOWING: FLORIDA: "IT IS UNLAWFUL, AND PUNISHABLE BY IMPRISONMENT AND FINE, FOR ANY ADULT TO STORE OR LEAVE A FIREARM IN ANY PLACE WITHIN THE REACH OR EASY ACCESS OF A MINOR UNDER 18 YEARS OF AGE OR TO KNOWINGLY SELL OR OTHERWISE TRANSFER OWNERSHIP OR POSSESSION OF A FIREARM TO A MINOR OR A PERSON OF UNSOUND MIND. " MAINE: "ENDANGERING THE WELFARE OF A CHILD IS A CRIME. IF YOU LEAVE A FIREARM AND AMMUNITION WITHIN EASY ACCESS OF A CHILD, YOU MAY BE SUBJECT TO FINE, IMPRISONMENT OR BOTH. KEEP FIREARMS AND AMMUNITION LOCKED UP USE TRIGGER LOCKS. " . CALIFORNIA: WARNING: CHILDREN ARE ATTRACTED TO AND CAN OPERATE FIREARMS THAT CAN CAUSE SEVERE INJURIES OR DEATH. [. . . ] During this movement the bolt cannot rotate due to the stabilizer pin which retains it. When the bolt scoops another round from the magazine and inserts it into the chamber, the locking lugs on the bolt come into contact with the recesses in the barrel and the bolt is rotated thus locking the cartridge in the chamber. Now the trigger bar is opposite the recess in the safety and can move upward, thus engaging the sear. When pulling the trigger, the sear releases the hammer which in turn hits the firing pin thus firing the chambered cartridge. 3) When the last cartridge is fired and the empty case is ejected, the slide is retained in its rear position by the slide catch. The slide catch is actuated by the magazine follower. The catch releases the slide when depressed by hand or when the slide is pulled slightly to the rear. fig. 3 18 Safety Features The safety catch levers are located at the rear of the slide, just below the rear sight. They are accessible from either side of the pistol. When pushing the front end of the safety catch lever downward, the safety catch is engaged. In this position the firing pin movement is closed by the safety catch and the trigger bar, which is pushed down, cannot engage the sear, thus neutralizing the trigger (fig. Telescopic sight (Mark XIX, . 357, . 44, . 440 & . 50) The 7/8" rib has cross-slots to allow installation of WeaverTM style rings. Telescopic sight (Mark I, VII, . 357, . 41, . 44) The existing 3/8" dovetail rib on the barrel is designed to accommodate a telescopic sight mount which is available as an option (#DEP350B). Zeroing 6 O'Clock DESERT EAGLE PISTOL combat sights designed for 6 o'clock hold, with top of front sight level with top of rear sight. Windage Adjust by shifting the rear sight (or the front sight) left or right as required. fig. 7 (Mark I pictured) 22 LOADING AND FIRING Pre-loading and Pre-firing checks: 1. Perform safety checks (see page 20) to ensure that the pistol is not loaded. Make sure the barrel is clean and free of obstruction. Check that the magazines are clean and properly loaded. Always wear ear and eye protection when firing the pistol. Never chamber a round unless you are ready to fire. The magazine will have about 1/16 inch play when seated properly. Do not push up on magazine when firing or jamming will occur. [. . . ] Clean or replace extractor or extractor spring. 4. Fouled or broken Clean or replace ejector ejector or ejector spring 5. Lead-fouled or broken return spring cross bar Clean or replace. Failure to do so can lead to a broken slide. Failure to fire - Hammer snaps home but gun will not fire. [. . . ]