User manual CARVIN 1588 V1

[. . . ] The PH50 is adequate for lengths up to 50' under normal use. You can DAISY-CHAIN up to one additional speaker per cable by using the unused 1/4" OUTPUT" jack (right side) on your speaker jack plate. Be sure to note the total impedance to the amp so it is not lower than it's recommended impedance. [. . . ] All components are integrated with our 3-way C1588 crossover to deliver a system response that is smooth from 34 Hz to 19k Hz. Bi-amping can easily be done by selecting the bi-amp switch and input connectors. 1) DO NOT EXCEED THE POWER RATING marked on the rear connect plate. 2) DISTORTION from power amps will destroy drivers much faster than clean power. 3) WATER, MOISTURE, and DUST are harmful to drivers causing failure which is not covered under warranty. WARRANTY CARVIN loudspeakers are covered by a ONE year limited warranty unless otherwise stated. Warranty coverage is limited to original manufactures defects only. WARRANTY DOES NOT COVER: 1) Opened or burned voice coils. 2) Torn cones caused by improper packing or abuse. When returning defective driver(s), remove them from the enclosure to reduce shipping costs . Include your address and description of the problem. Your driver(s) will be returned COD for the cost of shipping and reconditioning if not covered under warranty. 1588 FREQUENCY RESPONSE RECEIVING INSPECTION INSPECT YOUR SPEAKER FOR ANY DAMAGE which may have occurred during shipping. If any damage is found, please notify the shipping company & CARVIN. SAVE THE CARTON & ALL PACKING MATERIALS. In the event you have to re-ship your unit, always use the original carton and packing material. This will provide the best possible protection during shipment. CARVIN and the shipping company are not liable for any damage caused by improper packing. It will be required for warranty service if needed in the future. [. . . ] For greater coverage, add a second speaker system 20° to 30° off axis. TYPICAL LOUDSPEAKER IMPEDANCE CONFIGURATIONS Individual speaker or speaker cabinet wiring examples for total impedance. 8 TOTAL IMPEDANCE + + SERIES CONNECTION 16 TOTAL IMPEDANCE + + PARALLEL CONNECTION 4 TOTAL IMPEDANCE + + SERIES/PARALLEL CONNECTION 8 TOTAL IMPEDANCE + + 8 8 + + + 8 8 8 16 8 4 8 8 + 8 + 8 8 76-01588 0298 12340 World Trade Drive, San Diego, CA 92128 (619) 487-1600 (800) 854-2235 www. carvin. com HOOKUP DIAGRAMS NORMAL FULL RANGE HOOKUP MIXER OUT USA SPEAKER SYSTEM MODE SWITCH: FULL RANGE FULL RANGE POWER AMP INPUT Toll Free 1-800-854-2235 ADDITIONAL SYSTEM BIAMP SPK OUT 1 PROFESSIONAL SOUND REINFORCEMENT 4 800 Watts JACKS WIRED PARALLEL IN FULL RANGE MODE 1 588 SpeakonTM 1+SIGNAL 1­GROUND 2+ & 2­ NOT USED 1588 FULL RANGE ­PARALLEL BIAMP SW­LOW FREQ. INPUT 4 FULL RANGE­INPUT BIAMP SW­HI FREQ. INPUT 4 MADE IN THE USA BI-AMP HOOKUP MIXER OUT MIXER SPEAKER SYSTEM MODE SWITCH: BIAMP FULL RANGE POWER AMP INPUT SPK OUT 1 BIAMP PROFESSIONAL SOUND REINFORCEMENT 4 800 Watts JACKS WIRED PARALLEL IN FULL RANGE MODE FULL RANGE­INPUT BIAMP SW­HI FREQ. [. . . ]