User manual CARVIN AG100D2003

[. . . ] CARVIN ENGINEERING DATA AG100D ACOUSTIC/PA AMP Series III OPERATING MANUAL CONNECTING AC POWER TO YOUR AG100D · Use only a grounded (3 prong) power outlet to prevent a shock hazard. This also gives the quietest grounding for the amplifier CONNECTING INPUTS TO YOUR AG100D · Channel one is specially designed for acoustic and electric guitars using a 1/4" phone shielded cable. · Channel two is an instrument/line input. Any unbalanced device such as another guitar, tape recorders, drum machine, or keyboard can be plugged in using a 1/4" phone plug shielded cable. [. . . ] LO AND HI TONE CONTROLS The LO and HI tone controls are used to shape the bass and treble sound of the input signal. It is suggested that the tone control settings start in their center positions where they do not effect the signal. Then, as needed, turn the turn to the right to boost, or to the left to cut to change the sound. XLR MICROPHONE & 1/4" INPUT JACKS The MIC input is designed for balanced low impedance ( microphone ) input signals. The Balanced input will reduce the common noise picked up on the microphone cables. The XLR connector is wired as per the industry standard; pin 1 is ground, pin 2 is positive and pin 3 is negative. Phantom power is available on the XLR input jack. This allows condenser microphones to be run directly without the need for batteries or other external phantom power supplies. The 1/4" jack is designed for unbalanced high impedance signals (guitar, tape deck, drum machine, etc. ). Both of these inputs can be used at the same time. VOLUME CONTROL The VOLUME control adjusts the volume of the channel heard in the speaker, the line out jack, and the headphone jack. LO AND HI TONE CONTROLS The LO and HI tone controls are used to shape the bass and treble sound of the input signal. It is suggested that the tone control settings start in their center positions where they do not effect the signal. Then, as needed, turn the turn to the right to boost, or turn to the left to cut to change the sound. DIGITAL SIGNAL PROCESSING The 24 bit processor will provide a host of awesome sounding effects that include: Flange, Reverb, Echo, & Chorus. The master EFFECT 1 & 2 control will adjust the volume level of the selected effect. Remember each channel has its own EFFECT send level that will adjust the amount of signal sent to the effects processor. The red PK LED will indicate when the effects signal is clipping. Lower the channel EFFECT control until the PK LED stops flashing. (Note: When adjusting the effects on either channel, an audible noise may be heard). EFFECT PARAMETERS Each of the four effects has a variable parameter that can be easily adjusted. ECHO: When the top SELECT control is at the "7 O-clock" position, it is selected to the first ECHO setting where you get a single repeat echo (minimal regeneration). [. . . ] This warranty does not cover, and no liability is assumed, for damage due to: natural disasters, accidents, abuse, loss of parts, lack of reasonable care, incorrect use, or failure to follow instructions. This warranty is in lieu of all other warranties, expressed or implied. No representative or person is authorized to represent or assume for Carvin any liability in connection with the sale or servicing of Carvin products. CARVIN SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. [. . . ]