User manual CARVIN C1648P

[. . . ] C1648P 2000w Powered mixer C1648P REAR PANEL 1 C1648P REAR PANEL FEATURES: 1. SPEAKER OUTPUTS The combination SPEAKON jacks also accept 1/4" plugs. The minimum load for each amp is 4 OHMS. Chaining together more than one speaker on an output is fine as long as the total impedance is not below 4 ohms. [. . . ] Slide all faders down when connecting your inputs. miC PhANTom PowER SwiTCh / REd LEd This switch provides +48v power for condenser mics such as Carvin's CM90E in groups of 8 channels. This leaves the remaining MIC inputs for sources that don't require phantom power. The LINE inputs are unaffected. mASTER SECTioN 18. dUAL STEREo 24-biT EFFECTS PRoCESSoR The internal 24-BIT stereo processors receive signals from the channel EFF1 and EFF2 controls and the master EFF1 and EFF2 controls. If the adjacent PK (peak) LED flashes, reduce the level from the channel or master EFF1 or EFF2 send controls. A "solid" PK LED will show EFFEctS 1 or 2 have been muted by the MutE switches. The RETURN control will adjust the volume level of the selected effects. Remember each channel has its own two EFFECT sends that will send the signal to the effects processors. The red PK LED will indicate when the effects signal from the channel is distorting. Reduce the level of the channel EFFECT control until the PK LED stops flashing. EFFECT AND PARAMETERS a. )ECHO: When the SELECT control is at the "seven O-clock" position, it is selected to the first ECHO setting where you get a single repeat echo (minimal regeneration). Turning the PARAMETER control to 1 will provide the shortest delay time between the original signal and the echo. Increasing the PARAMETER control to the right will increase the time delay between the original signal and the echo. To increase the number of echo repeats, turn the SELECT control clockwise to "9 O-clock" (maximum regeneration). b. )REVERB: When the SELECT control is at the "ten O-clock" position, it is selected to the first REVERB setting. Turning the SELECT control clockwise will increase the amount of high frequencies in the reverb. Turning the PARAMETER control to 1 will provide minimal decay time of the reverb. Increasing to the right will increase the reverb decay time. c. )CHORUS: When the SELECT control is at the "one O-clock" position it is selected to the first CHORUS setting. Turning the SELECT control clockwise will increase the amount reverb in the chorus. Turning the PARAMETER control to 1 will provide a minimal chorus depth setting. [. . . ] If only one jack is used, the mono signal will go to both L/R . moNiToR 1-6 XLR oUTPUT CoNNECToRS The C48 SERIES provides balanced XLR outputs. Connect your monitor power amps to these connectors. GRoUP 1-4 oUTPUT JACKS The C48 SERIES provides 4 balanced 1/4" outputs. [. . . ]