User manual CARVIN LC24

[. . . ] This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. LIMITED WARRANTY Your Carvin product is guaranteed against failure for 1 YEAR unless otherwise stated. Carvin will service and supply all parts at no charge to the customer providing the unit is under warranty. Shipping costs are the responsibility of the customer. CARVIN DOES NOT PAY FOR PARTS OR SERVICING OTHER THAN OUR OWN. [. . . ] TO ENTER RECORDING MODE: Press and hold the RECORD button, now press­in sequence­the channel FLASH buttons 1, 5, 6, and 8 while still holding the RECORD button. Release the RECORD button and the RECORD LIGHT should be lit. RECORDING A SCENE PROGRAM: (A four step chase program saved into scene program location 28. ) · Enter Record mode: See A. * Set the mode LED's to 1x24 (or 2x12 depending on the light system used) Programming steps: · Raise the CHANNEL 1 FADER to max. The display should read 01 for step one. · Lower the CHANNEL 1 FADER to min. · Now raise the CHANNEL 2 fader to max · Press the RECORD button once. The display should read 02 for step two. · Lower the CHANNEL 2 FADER to min · Repeat for CHANNEL 3 and CHANNEL 4 FADERS. The display should increment each time the record button is pressed corresponding to the current step recorded. · To start over in a program, Press and hold the RECORD button and press the REC CLEAR button. Now the memory is cleared and the next step recorded will be step one of the new program. Storing the program · Press the PAGE button until the page LED over the "3" is lit. 11. ) HOME BUTTON In the Scenes mode this button, when activated, returns the SCENE FADERS and FLASH BUTTONS to controlling the Scene programs. 12. ) FADE FADER This fader adjusts the time a controlled light takes to go from the off to maximum intensity and the same time is used for going from maximum to off. 13. ) TAP SYNC BUTTON This button is used as an alternate way to define the chase speed in Scenes mode. When tapping this button the time between the last two taps is the new chase speed. This button over rides the Speed fader until the fader is used again. 14. ) SPEED FADER, 5MIN LED, & 10MIN LED This fader adjusts the chase speed in the Scene mode. Slowest speed is define in the two LED's above the fader 5min or 10min. To change the lowest speed to 5 minutes press and hold the RECORD button. While holding the RECORD button down, press channel 5's FLASH button three times. [. . . ] It is used to change the dimmer intensity in an existing program. In the record Edit mode, a steps dimmer intensity value is changed by pressing and holding the UP button, then as the FLASH button under the channel to be modified is pressed the intensity is increased. The alternate Chase Rev function works in the Scene mode and reverses the chase direction of the any programs running to a chase speed it will not rev scene programs that have their chase speed set by using the REC SPEED button. 31. ) BEAT REV / DOWN BUTTON The BEAT REV button works in the Scene mode with scene programs that have their chase speed set by the REC SPEED button and are now running with other programs with audio chase activated. [. . . ]