User manual CARVIN USM16MC

[. . . ] To start, you must have a USM16 compatible Carvin product, at least one USM16 receiver, and the USM16-KIT (includes mounting hardware, circuit board and antennas). If you have purchased this system seperately, please start with the installation procedure on the back page of this manual. If the unit has been pre-installed from the factory, you can follow these brief instructions to get you going quickly; REGULATIONS AND SERVICING This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. [. . . ] 12. 7 oz (360 grams) mic clip 90 days Net Weight Accessories Warranty For your records, you may wish to record the following information. Serial No. _____________________ Invoice Date_______________ c 12340 World Trade Drive, San Diego, CA 92128 USM16 1209 USM16-KIT INSTALLATION PROCEDURE: FOLLOW STEPS (A) THROUGH (E). LOOSEN AND REMOVE THESE TWO SCREWS KEEP FOR STEP (C) SLIDE THIS TAB INTO THE CONNECTOR ON CIRCUIT BOARD A B C D ANTENNA 1 SECURE CIRCUIT BOARD WITH SCREWS FROM (A) CONNECT THIS WIRE TO THE INTERNAL CONNECTOR ON YOUR CARVIN MIXER ANTENNA 2 (USE BOTH ANTENNAS AT ALL TIMES) E MOUNT THE UNIT(S) AND BRACKET TO YOUR CARVIN MIXER WITH SUPPLIED SCREWS FRONT PANEL CONTROLS TWO USM16 RECEIVERS MOUNTED WITH THE REQUIRED USM16-KIT LARGE CONSOLES CAN ACCEPT UP TO TO 4 RECEIVERS (2 USM16-KITs) 5 1 2 3 4 5 USM16 RECEIVER FRONT PANEL FEATURES 1. CHANNEL SELECTOR Use a small screwdriver to select your desired channel. The mic or belt-pack transmitter must be set to the same channel. RF LEVEL LED The RF level is displayed by an LED which allows you to estimate the RF signal strength. AF LEVEL LED The AF LED indicates the strength of the audio signal. VOLUME/OUTPUT CONTROL Adjusts the output audio level to the mixer. ANTENNAS Dual antennas for Diversity signal reception. Use both antennas at all times for best operation. TIPS TO OBTAIN THE BEST WIRELESS RESULTS 1. Replace batteries with every 25 hours of use. Position the receiver so that it has the fewest possible obstruction between it and the normal location of the transmitter. The transmitter and receiver should be as close together as conveniently possible. The receiver antenna should be in the open and away from any metal or cement walls. Turn the transmitter off when not in use. Remove the battery if the transmitter is not used for a period of time. IMPORTANT RF OPERATION NOTES Please note that wireless frequencies are shared with other audio services: According to Federal Communications Commission regulations, "Wireless microphone operations are unprotected from interference from other licensed operations within the band. If any interference is received by any Government operation, the wireless microphone must cease operation. . . " If you encounter receiving interference (from other than an operating TV station), often it can be eliminated by adjusting the receiver's antenna. LIMITED WARRANTY 90 days on all wireless electronic components. Does not cover cables, connectors, or broken parts caused by normal wear and tear or by dropping. Shipping costs are the responsibility of the customer. CARVIN DOES NOT PAY FOR PARTS OR SERVICING OTHER THAN OUR OWN. A COPY OF THE ORIGINAL INVOICE IS REQUIRED TO VERIFY YOUR WARRANTY. Carvin assumes no responsibility for horn drivers or speakers damaged by this unit. This warranty does not cover, and no liability is assumed, for damage due to: natural disasters, accidents, abuse, loss of parts, lack of reasonable care, incorrect use, or failure to follow instructions. [. . . ] Use a small flat-head screwdriver to change the channel. The mini XLR input jack will connect a Lavaliere mic, headset mic, or instrument cable to the transmitter. Line up the notches on the side of the jack and plug. Push in until the cable locks into the jack. [. . . ]