User manual CASABLANCA FAN COMPAGNY 19THCENTURY

[. . . ] 1 9TH CENTURY OWNERS MANUAL CONTENTS INTRODUCTION . 5 CONTROL FEATURES: INTELI·TOUCH OPERATION . 15 READ AND SAVE THESE INSTRUCTIONS SAFETY FIRST Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the product and proper installation; therefore, before attempting to install and operate your Casablanca fan, read this owner's manual completely and carefully. Retain this manual for future reference. [. . . ] Inspect each wire nut and ensure that no bare wire is visible; pull on each wire to test the connection is mechanically sound. WIRE NUT WIRE NUT INSTALL LIGHT KIT Step 17. Slide the light kit over the threaded pipe from the switch housing. Secure the light kit to the fan with the finial. Tighten securely by hand only. THREADED PIPE FINIAL 10 19th Century TM GLASS HARDWARE 60 WATT TYPE A15 INCANDESCENT BULB GLASS SHADE GLASS & BULB INSTALLATION Step 18. Loosen the three glass screws for each fixture so the end of the screws are flush with the inside of the fixture. Slide the glass shade into the fixture and hold firmly. Turn each screw several times, going in a circle, to assure that all glass screws have engaged the glass. Install the four 60 Watt type A15 bulbs into each fixture. CAUTION: TO REDUCE THE RISK OF FIRE USE MAX FOUR 60W STANDARD BASE A15 INCANDESCENT LIGHT BULBS Note: Do NOT use standard (A-19) bulbs. This commonly available size is too large in diameter; the proximity of the bulb to the glass will not allow for adequate air circulation. GLASS SHADE GLASS SHADE SCREWS 60 WATT TYPE A15 INCANDESCENT BULB OPTIONAL SWICH HOUSING CUP NOTE: This step is ONLY performed if you have chosen NOT to install the light kit. Slide the optional switch housing cup over the threaded pipe from the switch housing. Secure the cup to the fan with the finial. Tighten securely by hand only. THREADED PIPE OPTIONAL SWITCH HOUSING CUP FINIAL 11 R INTELI·TOUCH © INSTALLING THE W-32 WALL CONTROL The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed: 3. Do not use more than one fan per wall control. Use only the Casablanca W-32 wall control. Do not use any additional control with your Inteli-Touch 4. No other light fixtures or electrical appliances may be connected on the circuit controlled by the W-32 wall control fan (for example, dimmer, fan speed control, etc. ). unit. INTELI·TOUCH o SINGLE W-32 INSTALLATION CAUTION!Ensure power is turned OFF at the breaker or fuse panel before starting installation. W-32 is used to describe either white (-11) or ivory finish. Remove the screws and switch plate from the existing switch box. [. . . ] You may increase the fan speed by pressing and holding the button until the desired speed is reached, then release it. The fan will again reduce one speed for each 2 hour interval. 14 R TROUBLESHOOTING Before Requesting Service: Please follow this troubleshooting guide before contacting your dealer for assistance. Caring for Finishes: For cleaning, a soft brush or lint-free cloth should be used to prevent scratching the finish. A vacuum cleaner brush nozzle can remove heavier dust. Surface smudges or an accumulation of dirt and dust can easily be removed by using a mild detergent and slightly dampened soft cloth. [. . . ]