User manual CASABLANCA FAN COMPAGNY BELLA

[. . . ] BELLATM OWNER'S MANUAL CONTENTS INTRODUCTION . 3 CONTROL FEATURES: VERSA·TOUCH OPERATION . 10 READ AND SAVE THESE INSTRUCTIONS SAFETY FIRST Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the product and proper installation; therefore, before attempting to install and operate your Casablanca fan, read this owner's manual completely and carefully. Retain this manual for future reference. [. . . ] NOTE: The fan weight is 30 pounds. BALL SLOT PIN CANOPY ELECTRICAL CONNECTIONS Step 4. Attach the fan wires to the ceiling fixture outlet box wiring by twisting the bare ends of the wires together and then securing with a wire nut. Connect in this order: · GREEN leads from mounting plate and fan to GROUND conductor of power source. · WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. · BLACK wire from fan to black (or red) POWER wire in ceiling fixture outlet box. Secure with wire nut. WIRE NUT GREEN WIRES (3) BLACK WIRES (2) WHITE WIRES (2) 5 CANOPY HATCH INSTALLATION Step 5. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the WHITE and BLACK wires are on opposite sides of the canopy and all wires are clear of the canopy opening. Install canopy hatch with the last canopy screw and lock washer. To do this, tilt the fan body away from the hatch opening. Tighten the screws firmly by hand only, Step 7. Straighten the fan, then check to ensure that there is no movement between the canopy and ceiling or Hang-Tru ball and top support shaft. CANOPY HATCH LOCK WASHER TILT THE FAN TO INSTALL LAST CANOPY SCREW CANOPY SCREW BLADE & BLADE HOLDER HARDWARE BLADE SCREW (4 PER BLADE) BLADE HOLDER SCREW (2 PER BLADE) BLADE HOLDER BLADE BADGE BLADE BADGE INSTALLATION Step 8. Attach the blades to the blade holders by first pressing the blade badge into the blade, then installing the blade holder using the four blade screws and flat washers provided for each blade. Using the screwdriver, tighten securely by hand only. Repeat for each blade assembly. BLADE BADGE BLADE BLADE HOLDER BLADE SCREW (4 PER BLADE) BLADE ACCESS PLATE REMOVAL Step 9. Remove the blade access plate next to the light fixture. Install and tighten screws by hand only. Rocker Light Switch Step 1. Break off the two tabs by pushing outward. Remove the two screws holding the switch cover plate. Orient the control holder as shown and line up the two outer mounting holes with those on the switch. Install and tighten screws by hand only. VERSA·TOUCH o HOLDER INSTALLATION / STORAGE Wall Installation Step 1. Locate a 2x4 wall stud in a convenient location. Orient the control holder as shown over the 2x4 stud. [. . . ] ·Check the frequency setting: Turn power off, at the circuit breaker, only for the fan not functioning for at least 5 seconds; turn the power back on; within 20 seconds press the Hi, Med, and Lo buttons (in that order) to set the frequency of the fan to the control. See Page 9. FAN WOBBLES OR SHAKES ·Be sure canopy pin is properly set into the slot on the ball. EXCESSIVELY ·Check that bladeholders have not been bent during installation and blades are balanced. ·Hanger bracket and/or ceiling outlet are loosely attached: Make sure that the hanger bracket is tightly attached to the ceiling outlet box. [. . . ]