User manual CASABLANCA FAN COMPAGNY BRESCIAGALLERY

[. . . ] BRESCIATM (GALLERY EDITION) OWNER'S MANUAL 21 CONTENTS INTRODUCTION . 4 CONTROL FEATURES: INTELI·TOUCH OPERATION . . 11 INTELI·TOUCH TROUBLESHOOTING . 15 COMFORT·TOUCH TROUBLESHOOTING . [. . . ] Note: A four-toned signal indicates the command was accepted by the fan. A few seconds later the fan will slow to a stop and then reverse direction. INTELI·TOUCH OPERATION o LIGHT button for less To turn the lights off and on, press and release the than one second. With lights off, press and hold the button. After one second the lights come on at their lowest level and gradually become brighter. Release the button when the desired brightness level is reached. The brightness level is now in the fan memory and will automatically come on at the same brightness the next time the button is used. To maintain this level of brightness, press the button for less than one second. To lower the brightness, turn the lights off, then press and hold the button until the desired brightness level is reached. When the light is on, you may increase the brightness level by pressing and holding the button until the desired level is reached, then release it. LIGHT CONTROL ON - OFF A momentary press of the LIGHT button TO CHANGE BRIGHTNESS R PRESS AND HOLD LIGHT BUTTON LONGER THAN ONE SECOND AUTOMATIC DEMONSTRATION PROGRAM Programmed into every Inteli-Touch Series fan is an Automatic Demonstration Program. It can be used to fully demonstrate and test the operation of the fan. This will clear the fan memory ready for programming. Immediately operate the buttons in the following sequence: FAN - LIGHT FAN - LIGHT FAN A multi-tone signal will verify the start of the test program which proceeds as follows: · Lights slowly increase to full intensity. · Fan accelerates to speed three with audio tones. · Fan accelerates to full speed with audio tones. · Fan reverses at full speed with audio tones. · Fan power is reversed with audio tones. · Fan turns off with audio tones (blades coast for a short time). The complete cycle lasts slightly over one minute. It will continue to repeat until the is turned off for more than three seconds, cancelling the program. + + + + 12 R INTELI·TOUCH OPERATION o LIGHT-MINDER® PROGRAM The Light-Minder program automatically turns OFF the fan mounted lights after two hours. Turn the OFF for at least three seconds. Immediately operate the buttons in the following sequence: + + + 4. A series of tones indicates this command has been accepted. [. . . ] (All remote controls leave the factory as a BASE). Set both the controls to operate the fan. Select one of the remote controls to be the BASE unit. BASE DISPLAY BASE Check To confirm that the control is the BASE: for 3 seconds until a beep is 1. Confirm temperature display shows 'b'. [. . . ]