User manual CASABLANCA FAN COMPAGNY CAMPANA

[. . . ] CAMPANA TM OWNER'S MANUAL 3-Speed Model Only CONTENTS INTRODUCTION . 14 READ AND SAVE THESE INSTRUCTIONS SAFETY FIRST Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the product and proper installation; therefore, before attempting to install and operate your Casablanca fan, read this owner's manual completely and carefully. Retain this manual for future reference. CAUTION: To avoid possible electrical shock, make certain that electricity is turned off at the circuit breaker or fuse box before attempting any installation procedure. BEFORE YOU START · All wiring must be in accordance with the National Electric Code ANSI/NFPA 70-1993 and the appropriate local electrical codes. [. . . ] At the canopy, connect the BLACK and BLUE wires. SWITCH HOUSING COLLAR 3-SPEED OPTIONAL FAN ONLY WALL CONTROLS The W-40 and W-24 wall controls provide four-speed control of fan from a convenient wall location. The W-40 and W-24 are designed to replace a standard wall switch and will fit wall boxes with a depth of 2" or greater. Not for use with single pull-chain fan/light option wiring. R 3-SPEED OPTIONAL FAN AND LIGHT WALL CONTROLS The W-80 and W-28 wall controls provide separate control of fan and light with two separate controls. The W-80 and W-28 are designed to replace a standard wall switch and wall boxes with a depth of 2" or greater. Requires two hot leads from wall box to ceiling wiring box. LO 3-SPEED OPTIONAL REMOTE CONTROL Add remote control convenience to Casablanca 3-Speed fans. Adapt·Touch (W-52) easily converts new or existing Casablanca 3-speed Pull Chain fans equipped with a Hang-Tru canopy. Features include three fan speeds, instant off, and ful-range light dimming (on models equipped with a light fixture). The hand-held remote includes a switch plate bracket for wall mounting, and the receiver is quickly installed in the Hang-Tru canopy. Use one Adapt·Touch to control several fans, or purchase extra controls to operate a fan from different locacations. 9 OPTIONAL 3-SPEED W-40 WALL CONTROL · The W-40 allows the choice of four (4) different speed settings. · Set the FAN pull chain switch to the HIGH speed setting. · No changes in household or fan wiring are required. · The fan may be turned ON and OFF by the W-40 wall control. Failure to set the pull-chain speed to HIGH can result in faulty operation of the fan and damage to the W-40 wall control. To confirm fan is set to HIGH: Turn W-40 fan speed switch to 'HI' - set fastest fan speed with pull chain. R OPTIONAL W-80 WALL CONTROL OF THE FAN & LIGHT · The fan may be turned ON and OFF by the W-80 wall control. · The lights may be turned ON and OFF by the W-80 and the intensity adjusted from low to high. · The fan must be supplied with two independent 120V AC supply wires. · Set the FAN pull chain switch to the HIGH speed setting. · The W-80 allows the choice of four (4) different speed settings. CAUTION!Failure to set the pull-chain speed to HIGH can result in faulty operation of the fan and damage to the W-80 wall control. To confirm fan is set to HIGH: Turn W-80 fan speed switch to 'HI' - set fastest fan speed with pull chain. 10 TROUBLESHOOTING Before Requesting Service: Please follow this troubleshooting guide before contacting your dealer for assistance. Caring for Finishes: For cleaning, a soft brush or lint-free cloth should be used to prevent scratching the finish. A vacuum cleaner brush nozzle can remove heavier dust. Surface smudges or an accumulation of dirt and dust can easily be removed by using a mild detergent and slightly dampened soft cloth. [. . . ] ·Downrod is loosely attached to downrod base: Make sure that all screws are securely tightened . FAN NOISY DURING OPERATION ·Check and tighten light fixture retaining screws, glass shade screws and/or the light bulb(s). ·Tighten canopy screws and mounting plate assembly. Check that the wire nuts inside the canopy and switch housing are not touching the metal parts or have fallen off the wire splices. [. . . ]