User manual CASABLANCA FAN COMPAGNY MISSION

[. . . ] MISSION OWNERS MANUAL CONTENTS INTRODUCTION . 4 CONTROL FEATURES: INTELI·TOUCH OPERATION . 15 READ AND SAVE THESE INSTRUCTIONS SAFETY FIRST Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the product and proper installation; therefore, before attempting to install and operate your Casablanca fan, read this owner's manual completely and carefully. Retain this manual for future reference. [. . . ] Align the flat sides of the glass with the flat sides of the fan. Tighten the base nut securely. THREADED ROD GLASS ASSEMBLY BASE NUT SECURE GLASS Step 21. Slide the light kit cap over the threaded rod so that it is flush with the bottom of the glass. Align the light kit cap so that the blank panels match with the blank glass panels as shown. Thread the finial and tighten securely. BLANK PANEL LIGHT KIT CAP FINIAL 11 R INTELI·TOUCH© INSTALLING THE W-32 WALL CONTROL The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed: 1. Use only the Casablanca W-32 wall control. Do not use more than one fan per wall control. Do not use any additional control with your Inteli-Touch 4. No other light fixtures or electrical appliances may be confan (for example, dimmer, fan speed control, etc. ). nected on the circuit controlled by the W-32 wall control. INTELI·TOUCH o SINGLE W-32 INSTALLATION CAUTION!Ensure power is turned OFF at the breaker or fuse panel before starting installation. W-32 is used to describe either white (-11) or ivory finish. Remove the screws and switch plate from the existing switch box. Remove the screws holding the switch in the switch box. Pull the existing switch from the switch box to expose the wire connections. Connect the two wires just removed from the switch to the W-32 wall control black wire and black/white stripe wire. Secure these connections with wire nuts. Install the W-32 in the wall box with the two long screws provided. Install the wall plate with the two color matched screws. NOTE: If wall control operation is reversed (fan switch controls lights and light switch controls fan) turn off the power at the breaker or fuse panel, then swap the two W-32 black/white stripe wires. INTELI·TOUCH o DUAL W-32 INSTALLATION CAUTION! [. . . ] You may increase the fan speed by pressing and holding the button until the desired speed is reached, then release it. The fan will again reduce one speed for each 2 hour interval. 14 R TROUBLESHOOTING Before Requesting Service: Please follow this troubleshooting guide before contacting your dealer for assistance. Caring for Finishes: For cleaning, a soft brush or lint-free cloth should be used to prevent scratching the finish. A vacuum cleaner brush nozzle can remove heavier dust. Surface smudges or an accumulation of dirt and dust can easily be removed by using a mild detergent and slightly dampened soft cloth. [. . . ]