User manual CASABLANCA FAN COMPAGNY ZEPHAIR

[. . . ] DO NOT place fan or any parts near an open flame, cooking or other heating appliances. DO NOT operate any appliance with a damaged cord or plug, after the appliance malfunctions, or has been dropped or damaged in any manner. To disconnect, grip the plug and pull from wall outlet. To protect against electrical shock, do not immerse the fan, plug, or cord in water or spray with liquids. [. . . ] b) Before tightening down the collars be sure that the knob at the back of the motor housing is still in line with where the cord is coming out of the base. a) Align the tab from the base to the notch in the pipe. Thread and tighten the collar for the base of the fan, tighten completely. b) You may need to adjust the alignment of the knob at the back of the motor housing with the cord coming out of the base as you tighten the collars. The proper alignment of the notches in step 5 and step 10 will help keep this alignment as you tighten the collars. Set the floor fan up where the cord will not be in a traffic area or tripped on. Also make sure the oscillation movement of the cage is not impeded in any way. Step 5 TAB NOTCH Step 5 Step 8 Step 9 NOTCH TAB Step 10 OPERATING INSTRUCTIONS 1. Place the fan on a safe, flat surface where it cannot fall or be pulled by the cord. To set the horizontal direction of airflow, hold the fan housing neck in one hand, make sure the oscillating knob is in the up position and then turn the cage left or right. To control the vertical direction of airflow, grip the handle on top of the fan tightly and loosen the wing nut on the side of the fan housing neck. Adjust to the desired angle and tighten the wing nut. 5. To make the fan oscillate, push down on the oscillating knob located on the top of the fan housing, near the handle. To stop the fan from oscillating, pull up on the oscillating knob. 6a. To sleect a speed on the table model move the switch lever located on the base of the fan from OFF to the desired speed setting of 1 (low), 2 (medium) or 3 (high). To select a speed on the floor model, move the switch knob located on the back of the motor housing from OFF to the desired speed setting of 1 (low), 2 (medium) or 3 (high). OPTIONAL: To store the excess cord, unplug the fan from the wall socket and gently lay the fan on its side, making sure that the cage and motor are properly supported. To remove the base bottom unscrew all of the screws. Gently pull the cord through the bottom rubber bushing (assuring it remains in place) and through the cord restraint until you have the desired length. If the rubber bushing in the base has come loose, reinstall it into the base of the fan. Re-align the cord restraint to the proper position to reattach it to the base with the screw. Feed the excess cord into the neck of the base. For the table fan, keep it away from the speed switch assembly. [. . . ] Warranty motor repairs must come back to the factory for replacement. Casablanca will not pay for shipping charges incurred in sending the defective product from the customer to Casablanca Fan Co. , but will pay for return UPS shipment. The repair or replacement of a product is your exclusive remedy. Any implied warranty of merchantability or fitness is limited to the duration of this written warranty. [. . . ]