User manual CASIO 2575

[. . . ] MO0303-B USER'S GUIDE 2575 About This Manual · Button operations are indicated using the letters shown in the illustration. · Each section of this manual provides you with the information you need to perform operations in each mode. Further details and technical information can be found in the "Reference" section. (Light) General Guide · Press C to change from mode to mode. [. . . ] · If the countdown start time is not displayed, use the procedure under "To use the countdown timer" to diplay it. Press C to move the flashing between the hour and minute settings. Use D (+) and A (­) to change the flashing item. · To set the starting value of the countdown time to 100 hours, set 0:00. Press B to exit the setting screen. To turn the pacer signal on and off 1. While the Stopwatch Mode screen shows all zeros (0 H00'00''00), hold down B until the pacer value appears flashing on the display. Press C once to display the pacer signal setting screen. Press D to toggle the pacer signal on (ON) and off (OFF). · A pacer signal on indicator ( ) appears when this setting it turned on. Press B to exit the setting screen. To use the countdown timer Press A while in the Countdown Timer Mode to start the countdown timer. · When the end of the countdown is reached and auto-repeat is turned off, the alarm sounds for 10 seconds or until you stop it by pressing any button. The countdown time is automatically reset to its starting value when the alarm sounds. · Press A while a countdown operation is in progress to pause it. · To completely stop a countdown operation, first pause it (by pressing A), and then press D. This returns the countdown time to its starting value. To turn auto-repeat on and off While the countdown start time is displayed on the Countdown Timer Mode screen, hold down D for about two seconds to toggle auto-repeat on ( displayed) and off ( not displayed). · When auto-repeat is turned on, the alarm sounds and countdown starts again whenever the countdown reaches zero. You can stop the countdown by pressing A, and manually reset to the countdown start time by pressing D. · Auto-repeat timing repeats up to seven times. Recall Mode Distance covered Log number Use the Recall Mode to recall and delete records stored by the Stopwatch Mode. · Stopwatch records are stored in "logs" that are created automatically by the watch. See "Memory Management" for more information. · The title screen of the newest log appears first whenever you enter the Recall Mode. [. . . ] · Pressing B sets the Dual Time Mode to the same time as the Timekeeping Mode. Timekeeping Mode time Backlight Auto light switch on indicator The backlight uses an LED (light-emitting diode) and a light guide panel that cause the entire display to glow for easy reading in the dark. The watch's auto light switch automatically turns on the backlight when you angle the watch towards your face. · The auto light switch must be turned on (indicated by the auto light switch on indicator) for it to operate. · See "Backlight Precautions" for other important information about using the backlight. 61 Records To turn on the backlight manually In any mode, press L to illuminate the display for about one second. [. . . ]