User manual CASIO 2866

[. . . ] MO0312-EA Operation Guide 2866 2867 Getting Acquainted Congratulations upon your selection of this CASIO watch. To get the most out of your purchase, be sure to carefully read this manual and keep it on hand for later reference when necessary. Expose the watch to bright light to charge its battery before using it. You can use this watch even as its battery is being charged by exposure to bright light. [. . . ] · Exiting the Stopwatch Mode while a split time is frozen on the display clears the split time and returns to elapsed time measurement. · The stopwatch measurement operation continues even if you exit the Stopwatch Mode. Home city time · All of the operations in this section are performed in the 1/100 second Stopwatch Mode, which you enter by pressing C. Hours To measure times with the stopwatch Elapsed Time D Start D Stop D Re-start D Stop B Clear Split Time D Start B Split B Split release D Stop B Clear Two Finishes D Start B Split First runner finishes. Display time of first runner. || | | To set the time and date manually 1. In the Timekeeping Mode, hold down A until the city code setting starts to flash, which indicates the setting screen. Use A or C to move the flashing in the sequence shown below to select other settings. Press C. C City/Transmitter Settings City Code Press A. Transmitter Mode DST Time/Date Settings 12/24-Hour Format Power Saving C Seconds Day Hour Month Minutes Year 3. When the setting you want to change is flashing, use B and/or D to change it as described below. City/Transmitter Settings Screen: BER qvtA DST To do this: Do this: Change the city code Change the transmitter mode (qvtA, DCF, MSF, or OFF) Toggle between Daylight Saving Time (ON) , Standard Time (OFF), or Auto DST (AUtO) Use D (east) and B (west). Press D. AUtO · See "City Code Table" for a complete list of available city codes. · The transmitter mode setting is always OFF and cannot be changed whenever the city code setting is anything other than LON, PAR, BER, or ATH. Time/Date Settings Screen: 12H P To do this: Do this: 10:58 50 '04 Toggle between 12-hour (12H) and 24-hour (24H) timekeeping Reset the seconds to 00 Change the hour or minutes Change the year, month, or day Press D. Use D (+) and B (­). 6x30 PS ON Toggle power saving on (ON) and off Press D. · If a City/Transmitter Setting screen is displayed, press A twice. · If a Time/Date Setting screen is displayed, press A once. Note · The "Transmitter Mode" setting specifies the time calibration signal transmitter mode, or turns auto receive off. See "Transmitters" for more information. · Auto DST (AUtO) can be selected only while LON, PAR, BER, or ATH is selected as the Home City code. For more information, see "Daylight Saving Time (DST)" below. Daylight Saving Time (DST) Daylight Saving Time (summer time) advances the time setting by one hour from Standard Time. Remember that not all countries or even local areas use Daylight Saving Time. The time calibration signals transmitted from Rugby and Mainflingen include both Standard Time and DST data. When the Auto DST setting is turned on, the watch switches between Standard Time and DST (summer time) automatically in accordance with the received time signal. [. . . ] If the Rugby signal cannot be received, or after the city code has been changed. Checks the last successfully received signal first. If the last successfully received signal cannot be received, checks the other signal. · Time calibration auto receive is turned on whenever the transmitter mode is qvtA, DCF or MSF. [. . . ]