User manual CASIO 3053

[. . . ] MO0609-EA Operation Guide 3053 Getting Acquainted Congratulations upon your selection of this CASIO watch. To get the most out of your purchase, be sure to read this manual carefully. Your watch is shipped with it Auto Display feature (which continually changes the contents of the digital display) turned on. Calibration signal reception is disabled while Auto Display is turned on. [. . . ] · For full information on city codes, see the "City Code Table". lll ll ll lll Last Signal Screen Receive date The World Time Mode shows you the current time in 48 cities (29 time zones) around the world. · If the current time shown for a city is wrong, check your Home City time settings and make the necessary changes. · All of the operations in this section are performed in the World Time Mode, which you enter by pressing C. L Receive time 2 Operation Guide 3053 To toggle a city code time between Standard Time and Daylight Saving Time 1. In the World Time Mode, use D to display the city code DST indicator (time zone) whose Standard Time/Daylight Saving Time setting you want to change. Hold down A to toggle Daylight Saving Time (DST indicator displayed) and Standard Time (DST indicator not displayed). · The DST indicator will appear whenever you display a city code for which Daylight Saving Time is turned on. · Note that the DST/Standard Time setting affects only the currently displayed city code. To set the alarm time ll lll lll 1. In the Alarm Mode, hold down A until the hour setting of the alarm time starts to flash, which indicates the setting screen. · This automatically turns on the alarm. Press C to move the flashing between the hour and minute settings. 3. While a setting is flashing, use D (+) and B (­) to change it. · When setting the alarm time using the 12-hour format, take care to set the time correctly as a. m. Press A to exit the setting screen. Countdown Timer Timekeeping Mode time (Hour : Minutes Seconds) Alarm Operation You can set the countdown timer within a range of one to 60 minutes. An alarm sounds when the countdown reaches zero. · All of the operations in this section are performed in the Countdown Timer Mode, which you enter by pressing C. The alarm sounds at the preset time for about 10 seconds (in all modes), or until you stop it by pressing any button. To test the alarm In the Alarm Mode, hold down D to sound the alarm. To turn the daily alarm and the Hourly Time Signal on and off In the Alarm Mode, press D to cycle through the settings shown below. Alarm On Indicator / Hourly Time Signal On Indicator Minutes Seconds To set the countdown start time 1. While the countdown start time is on the display in the Countdown Timer Mode, hold down A until the current countdown start time starts to flash, which indicates the setting screen. · If the countdown start time is not displayed, use the procedure under "To use the countdown timer" to display it. While a setting is flashing, use D (+) and B (­) to change it. To use the countdown timer Press D while in the Countdown Timer Mode to start the countdown timer. [. . . ] It also contains important precautions and notes about the various features and functions of this watch. Auto Display Auto Display continually changes the contents of the digital display. To turn off Auto Display Press any button to turn off Auto Display. To turn on Auto Display In the Timekeeping Mode, while holding down B, hold down D for about two seconds until the watch beeps. Note · Calibration signal reception is disabled while Auto Display is being performed. · Auto Display cannot be performed while a setting screen is on the display. Illumination This watch has an EL (electro-luminescent) panel that causes the entire display to glow for easy reading in the dark. In any mode (except when a setting screen is on the display), press B to illuminate the display for about three seconds. [. . . ]