User manual CASIO COMBIWAVE1

[. . . ] MO0610-EA Operation Guide COMBIWAVE1 About This Manual · The operational procedures for Modules 2735, 3747, and 4772 are identical. All of the illustrations in this manual show Module 2735. · Button operations are indicated using the letters shown in the illustration. · This watch does not have a time zone that corresponds to the Greenwich Mean Time differential of ­3. 5 hours. [. . . ] Note that the target alarm repeats automatically each day, as long as it is turned on. You need to turn off the target alarm to disable it. · Pressing any button stops the alarm tone operation. · Performing any one of the following operations during a 5-minute interval between snooze alarms cancels the current snooze alarm operation. Displaying the Timekeeping Mode setting screen Displaying the snooze alarm setting screen Alert Off Time Recorder Current time (Hour : Minutes) To test the alarm In the Alarm Mode, hold down D to sound the alarm. In the Alarm Mode, use D to select an alarm. · Turning on a one-time alarm (AL1, AL2, AL3, TAL) displays the alarm on indicator on its Alarm Mode screen. Turning on the snooze alarm (SNZ) displays the alarm on indicator and snooze alarm indicator on its Alarm Mode screen. Snooze alarm indicator · In all modes, the alarm on indicator is shown for any Modules 2735 and 4772 alarm that is currently turned on. When the snooze alarm is on, the snooze alarm indicator is displayed in all Alarm on indicator modes. · The alarm on indicator flashes while the alarm is sounding. · The snooze alarm indicator flashes during the 5-minute intervals between alarms. Snooze alarm indicator Standby Screen 2. Press D to record the current date and time (month, day, hour, minutes). · The recorded time flashes for about two seconds and then assigned the next available record number, in the range of T1through T30. Next the time recorder standby screen appears. · A new time is recorded each time you press D while the standby screen is on the display. · Records are assigned numbers sequentially from T1through T30. · Storing a new time record when there are already 30 records stored in memory automatically deletes record T1 shifts the remaining records upwards by 1, and , stores the new record as T30. To recall Time Recorder times 1. In the Time Recorder Mode, press A to recall Time Recorder times. · If there are no time recorder times currently in memory, the standby screen remains on the display when you press A. Use D to scroll through times stored in memory. Recorded time (Hour : Minutes) Recorded date (Month ­ Day) Module 3747 To turn the Hourly Time Signal on and off 1. In the Alarm Mode, use D to select the Hourly Time Signal (SIG). Press A to toggle it on (the Hourly Time Signal on indicator displayed) and off (the Hourly Time Signal on indicator not displayed). [. . . ] · If you have problems with proper time calibration signal reception or if the time setting is wrong after signal reception, check your current city code, DST (summer time), and auto receive settings. The following are the initial factory defaults for these settings. Setting Initial Factory Default City code NYC (New York) DST (summer time) A (Auto switching) DST Auto receive ON (Auto receive) R/C Timekeeping · Resetting the seconds to 00 while the current count is in the range of 30 to 59 causes the minutes to be increased by 1. In the range of 00 to 29, the seconds are reset to 00 without changing the minutes. [. . . ]