User manual CASIO FR-620RE-E-EC

[. . . ] € Switch power off after use or if you do not plan to use the calculator. It is best to unplug from the AC outlet if you do not plan to use the calculator for a long time. € The contents of these instructions are subject to change without notice. Assumes no responsibility for any loss or claims by third parties which may arise from the use of this product. [. . . ] The first line of a j operation will be “• • • • 0 • • • •”. - You can reprint data that has already been printed. (Reprint) - You can print a calculation, even if printing was turned off when you performed it. (After Print) • To stop printing , press j again or v. € If you change the Function Selector position during a calculation, pressing j will not print the calculation. in this case , pressing j will display no Print”. € After performing the tax rate setting or display operation, j is disabled until you press v. € If the message “FULL” appears when you press j, it means that calculation memory is full. - Calculation memory can hold up to 150 steps. (Example: 1+ is one step, 1+2+ is two steps. ) - To print current memory contents after “FULL” appears, press j again. The first line of the printout will show • • • 1 • 150 • • • . - To return the calculator to its state before you pressed j above without printing, press c. K After Print, Reprint k About the Selectors k Acerca de los selectores k A propos des sélecteurs k Über die Wahlschalter k Cenni sui selettori k Angående väljarna k Betreffende de keuzeschakelaars k Angående innstillingsvelgerene OFF ON PRINT ITEM MEMORY F: Floating decimal CUT: Cut off to the number of decimal places specified by the Decimal Place Selector setting. UP: Round up to the number of decimal places specified by the Decimal Place Selector setting. 5/4: Cut off (0, 1, 2, 3, 4) or round up (5, 6, 7, 8, 9) to the number of decimal places specified by the Decimal Place Selector setting. The total number of addition and subtraction items is printed with the result when : and & are pressed. Pressing the G key prints the number of items (number of & key operations) added to the grand total memory. mEMORY: Power is on and printing is activated. Independent memory functions (M+, M−, MZ, M`) are enabled. Pressing the E or y key prints the total number of q and w key operations up to that point along with the value stored in the independent memory. € Note that currency conversion is disabled while the Function Selector is set to MEMORY. [. . . ] For rates less than 1, you can input up to 8 digits, including 0 for the integer digit and leading zeros (though only six significant digits, counted from the left and starting with the first non-zero digit, can be specified). 0012345 • You can check the currently set rate by pressing v and then u. For kurser som er mindre enn 1 kan opp til 8 sifre tastes inn inklusive 0 for heltallet og etterfølgende nuller (kun seks signifikante sifre kan imidlertid spesifiseres, startende med første tall som ikke er null). 8320 • You can check the currently set rate by pressing v and then S. [. . . ]