User manual CASIO ID-16

[. . . ] MA0505-EA Operation Guide ID-16 ILLUSTRATION GENERAL GUIDE 1 + / ­ buttons Use these buttons to change the setting that is flashing on the display. 2 °C/°F button Press this button to toggle the temperature units between Celsius and Fahrenheit. [. . . ] the flashing · Each press of + or ­ while the 12-hour/24-hour digits. Timekeeping Screen is on the display toggles Press ­ to decrease the flashing digits. 1cm between 12-hour and 24-hour timekeeping. After making the settings you want, use the SET button (3) to display the Normal Timekeeping Screen. · The clock automatically returns to the Normal Timekeeping Screen if you leave a setting screen on the display for about three minutes without performing any operation. THERMOMETER FUNCTIONS · A built-in sensor measures temperature and shows the measured value on the display. · The temperature display shows "LO" for temperatures below ­50°C (­58°F) and "HI" for temperatures above 70°C (158°F). · Though temperature readings are displayed up to 0°C (32°F) and greater than 41°C (105°F), note that such readings are actually outside the guaranteed temperature range of this clock. · A sticker is affixed to the glass of the clock when you purchase it. Be sure to remove the sticker before using the clock. · Depending on the clock model, its configuration may differ somewhat from that shown in the illustration. Date (month - day) Day of the week Current time (Hour, minutes, seconds) Switching between Celsius and Fahrenheit Celsius (°C) · Push the °C/°F button (2) to select either Celsius (°C) or Fahrenheit (°F). Fahrenheit (°F) °C/°F button (2) PM indicator °C Current temperature Current humidity °F 1 Operation Guide ID-16 HYGROMETER FUNCTIONS A built-in sensor measures humidity and shows the measured value on the display. · The humidity display shows "LO" for humidity below 10% and "HI" for humidity above 90%. BATTERY REPLACEMENT Replace batteries whenever the display of the clock becomes dim and difficult to read. Open the battery compartment cover as shown in the illustration. Make sure that their positive (+) and negative (­) ends face in the correct directions. If you load batteries incorrectly, they can burst and damage the clock. [. . . ] · Replace the batteries at least once a year, even if the current batteries are working properly. · The batteries that come with the clock lose some of their power during transport and storage. 2 [. . . ]