User manual CASIO KL-100E

[. . . ] KL-100E User's Guide Important Safety Precautions Note of the following safety precautions before using the label printer for the first time. Keep these safety precautions and operating instructions on hand for future reference. About safety precaution symbols The following symbols are used in this manual and on the product itself to alert you and others to the risk of personal and material injury. Warning This symbol indicates an item that can result in death or serious personal injury if ignored. Caution This symbol indicates an item that can result in serious personal injury or material damage if ignored. AC adaptor · Do not allow the power cord to become damaged or broken, and never modify, over bend, twist, or pull it. [. . . ] If both the caps mode indicator and the shift indicator are shown on the display, the keyboard is shifted to lower-case input. · Effect indicators These indicators point to the character effect that is currently in use. You can select between shading, underline, and box. · Stamp printing indicator This indicator appears when the Label Printer is set up for stamp printing. Labels you create with stamp printing can be attached to an optionally available stamp holder and then used as a pre-inked stamp. · Mirror image printing indicator This indicator appears when the Label Printer is set up for mirror image printing. Normal (non mirror image) printing is performed when this indicator is not shown. Display Symbols and Indicators Before getting into actual input, you should first become acquainted with the symbols and indicators used on the Label Printer display. Function indicator Effect indicators Stamp printing indicator Shift indicator Code indicator FUNCTION SHIFT CODE CAPS AAA CAS Cursor STAMP MIRROR M-FEED 6mm Mirror image printing indicator Manual feed indicator Caps indicator 6mm tape indicator Character position marks · Function indicator This indicator appears when you press the FUNCTION key. Pressing a key while this indicator is on the display causes the function marked above that key to be executed. E-9 · Manual feed indicator This indicator appears when you are using manual feed instead of auto feed. Auto feed is in effect when this indicator is not on the display. · After you finish printing when using manual feed, be sure to always press FUNCTION and then PRINT (FEED) to feed the tape before cutting it. If you don't you will cut off part of the printed text. · 6mm tape indicator This indicator appears when you use the procedure on page 8 to specify you are using 6mm tape. No indicator is shown when you are using other (9mm, 12mm, 18mm) tape. · Cursor The cursor shows the next input position. Any character you input appears at the point where the cursor is located. · Character position marks These marks show where characters will appear as you input them. This part of the display is always blank when you turn power on. · If you input a wrong character, press BS to delete it and input again. See page 11 for other details on editing text. When you reach the end of a line of text, press B (the L cursor key) to input a newline mark. · A newline operation is indicated on the display by the B symbol. Input the characters in the second line. To print the text that you input, press PRINT. [. . . ] Remove the tape cartridge and reload it correctly. Clean the printer head and roller. · Using Labels Label will not adhere to a surface. Possible Causes The backing paper is still on the back of the tape. Surface is unsuitable for affixing a tape. [. . . ]