User manual CASIO KL-60

[. . . ] KL-60 User's Guide ESGFISw Important Safety Precautions Note of the following safety precautions before using the label printer for the first time. Keep these safety precautions and operating instructions on hand for future reference. Batteries · Never charge batteries, try to take batteries apart, or allow batteries to become shorted. Never expose batteries to direct heat or dispose of them by incineration. Tape Cutter · Never touch the tape cutter while a tape cut operation is being performed. [. . . ] Return the printer head release to its original position by sliding in the direction opposite to that indicated by the arrow in the illustration in step 5. Turn on Label Printer power and press FUNC and then PRINT (FEED) two or three times to make sure that the tape comes out without any problem. · If the tape does not come out normally, turn off power and start again from step 1 above. Before getting into actual input, you should first become acquainted with the symbols and indicators used on the Label Printer display. Function indicator Effect indicators A A A MIRROR 6mm TAPE:6~12mm Mirror image printing indicator Tape Width Specification Important!· When using 6mm tape, using certain character sizes can cause characters to run off the top or bottom of the tape. Be sure to use the following procedure to tell the Label Printer when you are using 6mm tape. Shift indicator Code indicator FUNCTION SHIFT CODE CAPS CAS KL-60 6mm tape indicator Caps indicator Cursor Character position marks E-7 · Function indicator This indicator appears when you press the FUNC key. Pressing a key while this indicator is on the display causes the function marked above that key to be executed. · Shift indicator This indicator appears when you press the SHIFT key. While this indicator is on the display, the keyboard is shifted, so the letter keys input upper-case alpha characters. The number keys input the punctuation symbols marked in the upper right corners of the keys. If both the caps mode indicator and the shift indicator are shown on the display, the keyboard is shifted to lower-case input. The keyboard automatically unshifts (and the shift indicator disappears) as soon as you input a character. · Code indicator This indicator appears when you press the CODE key. While this indicator is on the display, number keys 1 through 0 input the accents marked above them and the U, O, P, A, S, J, K, L, Z, C and N keys input the special characters marked in their lower right corners. The keyboard automatically returns to normal (and the code indicator disappears) as soon as you input an accent. · Caps indicator This indicator appears when the Label Printer is in the caps (upper-case) mode. All letters you input in the caps mode are upper-case. When the caps mode indicator is not shown on the display, all letters are input as lower-case. Note that the Label Printer stays in the caps mode until you press the CAPS key again. If both the caps mode indicator and the shift indicator are shown on the display, the keyboard is shifted to lower-case input. · Effect indicators These indicators point to the character effect that is currently in use. You can select between shading, underline, and box. [. . . ] Cut off excess tape with scissors, and carefully replace the cartridge into the label printer. Never allow the tape outlet to become blocked and never touch tape as it is being fed during printing. E-15 · Tape Cutting Cannot cut tape. Possible Cause Tape cutter blade is dull. Action Take the label printer to the dealer from whom you purchased it to have the tape cutter blade replaced. Error Messages Message BATT ERR! [. . . ]