User manual CASIO KL-7200

[. . . ] KL-7200 User's Guide Important Safety Precautions Note of the following safety precautions before using the label printer for the first time. Keep these safety precautions and operating instructions on hand for future reference. About safety precaution symbols The following symbols are used in this manual and on the product itself to alert you and others to the risk of personal and material injury. Warning This symbol indicates an item that can result in death or serious personal injury if ignored. Caution This symbol indicates an item that can result in serious personal injury or material damage if ignored. AC adaptor · Do not allow the power cord to become damaged or broken, and never modify, over bend, twist, or pull it. [. . . ] All letters you input in the caps mode are upper-case. When the caps mode indicator is not shown on the display, all letters are input as lower-case. Note that the Label Printer stays in the caps mode until you press the CAPS key again. If both the caps mode indicator and the shift indicator are shown on the display, the keyboard is shifted to lower-case input. · Effect indicators These indicators point to the character effect that is currently in use. You can select between shading, underline, and box. · Style indicators These indicators point to the character style that is currently in use. You can select between normal, outline, shadow, and raised. · Mirror image printing indicator This indicator appears when the Label Printer is set up for mirror image printing. Normal (non mirror image) printing is performed when this indicator is not shown. Display Symbols and Indicators Before getting into actual input, you should first become acquainted with the symbols and indicators used on the Label Printer display. Mirror image printing indicator Function indicator Effect indicators A FUNC SHIFT CODE CAPS Style indicators A A A A MIRROR M-FEED Shift indicator A Code indicator Caps indicator Cursor Character position marks Manual feed indicator · Function indicator This indicator appears when you press the FUNC key. Pressing a key while this indicator is on the display causes the function marked above that key to be executed. E-9 · Manual feed indicator This indicator appears when you are using manual feed instead of auto feed. Auto feed is in effect when this indicator is not on the display. · After you finish printing when using manual feed, be sure to always press FUNC and then PRINT (FEED) to feed the tape before cutting it. If you don't you will cut off part of the printed text. · Cursor The cursor shows the next input position. Any character you input appears at the point where the cursor is located. · Character position marks These marks show where characters will appear as you input them. This part of the display is always blank when you turn power on. 3. When you reach the end of a line of text, press B (the L cursor key) to input a newline mark. · A newline operation is indicated on the display by the B symbol. · The maximum number of lines you can input depends on the width of the tape you have loaded in the Label Printer. Tape Width Maximum Number of Lines · 6mm . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When the printer is set up for manual tape feed, the tape is not fed automatically after printing is complete. Out of tape E-22 Replace the tape cartridge with a new one. E-17 Page E-7 · Using Labels Label will not adhere to a surface. Possible Causes The backing paper is still on the back of the tape. [. . . ]