User manual CASIO SF-9700

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Press FUNC and then select "Define type". Use K and L to move the pointer to the schedule type you want to change. Input up to 13 characters for the new label you want to use. Skip this step if you don't want to change the label or if you want to wait until after you change the schedule type icon. 5. Press DISP CHNG to display the menu of schedule type icons. If you do not want to change the icon assigned to this schedule type, skip steps 5 through 7. Use K, L, H and J to move the cursor to the icon you want to use. Use " and ` to move between menu screens. When the icon you want is selected, press OK to register it and return to the schedule type menu. Press OK to store all your changes and return to the initial Schedule Keeper Mode display. You could change the schedule type label before pressing OK in step 8 if you have not already done so. To specify Schedule Keeper Mode index display contents 1. After setting the alarm, press OK to advance to icon input. At this time the icon in the upper right of the display starts to flash. If you do not want to change the icon, skip steps 6 and 7. Use K, L, H and J to move the flashing cursor to the icon you want to use. Use " and ` to move between menu screens. When the icon you want is selected, press OK to register it and return to the Reminder input screen. While the cursor is in the description area, press OK to store all the data. 39 40 Note You must input a description. After that, you can skip any input by pressing OK without inputting anything. I Reminder Alarms When a Reminder Alarm time is reached, an alarm sounds for 20 seconds and the corresponding Reminder data appears on the display. Press any key to stop the alarm and return to the screen that was shown before the alarm began to sound. Note the following important points when you are using a Reminder Alarm. [. . . ] While the index display or data display is on the screen, press FUNC and then select "Send all records". This causes the message "READY TO SEND (Y/N)?" to appear, so press Y to send or N to abort. To send all data items from a single file mode (Schedule Keeper, Reminder) 1. Display the initial screen of the mode that contains the data you want to send. Press FUNC and then select "Send all records". [. . . ]