User manual CASIO TI-310 Installation Instruction

[. . . ] IMPORTANT SAFETY INSTRUCTIONS INSTALLATION INSTRUCTIONS 1. Never install telephone wiring during a lightning storm. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. [. . . ] If liquid has been spilled into the product. If the product has been exposed to rain or water. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions because improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation. If the product has been dropped or the cabinet has been damaged. If the product exhibits a distinct change in performance. 12. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning. 13. Do not use the telephone to report a gas leak while near the leak. LISTENING TO MESSAGES (OPTION 1) 1 1 After the access code has been entered, messages will automatically be played. 1 2 3 If your TI-310 is currently playing back messages, press 1 on your keypad to pause playback. Press 3 on your telephone keypad, a beep will be heard, begin recording your new greeting. Press 3 on your telephone keypad when finished speaking. Your new greeting will play automatically. 1 2 1 Press 8 on your keypad after hearing "End of messages. " to turn the answering machine off. Upon exiting remote operation, the unit will be turned off and no further messages will be recorded. In the event you accidentally turned your answering machine off, press 7 on your keypad to turn the unit back on. EASY TO USE OWNER'S GUIDE TI-310 Telephone with Digital Answering Machine PAUSING MESSAGES During playback of the message you want paused, press 1 on your keypad. Messages will be paused for up to one minute before disconnecting. To resume playback, press 1 again. NOTE: s There is a one minute maximum for recording your greeting through remote operation. EXITING REMOTE OPERATION (OPTION 9) Press 9 on your keypad at any time during remote operation to exit. SKIP BACKWARD (OPTION 4) ERASE MESSAGES (OPTION 2) 1 1 1 Press 4 on your keypad to skip back to the previous message. REPEAT MESSAGE (OPTION 5) Press 5 on your keypad to repeat the current message. MESSAGE RETRIEVAL WHEN MEMORY IS FULL If the TI-310's memory is full, you will hear three short beeps followed by, "Memory full. " To retrieve messages remotely when the TI-310's memory is full: 1 2 During playback of the message you want erased, press 2 on your touchtone keypad. To confirm deletion of the message, you will hear a beep. To erase all messages, press 2 after hearing "End of Messages. " You will hear a beep and all messages will be erased. SKIP FORWARD (OPTION 6) Press 6 on you keypad to skip forward to the next message. 1 2 Enter your 3-DIGIT ACCESS as the greeting plays. CODE After listening to messages, you may press 2 on the keypad to erase all messages and allow callers to leave new messages. Turn over for installation instructions SAVE THESE INSTRUCTIONS FCC REQUIREMENTS USER INSTRUCTIONS 1. This equipment complies with Part 68 of the FCC rules. On the bottom of this equipment is a label that contains, among other information, the FCC registration number and Ringer Equivalence Number (REN) for this equipment. If requested, provide this information to your telephone company. The REN is useful to determine the quantity of devices you may connect to your telephone line and still have all of those devices ring when your number is called. [. . . ] Guide the telephone cord through the right cord holder on the unit's bottom. Tightly coil the telephone cord around the four guides on the in-side of the wall mounting bracket. Pull the telephone cord through the center opening on the wall mounting bracket. Guide the AC Adapter through the left cord holder on the bottom of the unit. [. . . ]