User manual CASTOR C141TT

[. . . ] U-Line products are making life more convenient in homes, businesses, and hotels around the world. U-Line supports its products with a strong dealer network, and its commitment to quality even extends to environmentally safe packaging. IMPORTANT READ all of the instructions in this guide completely before operating the unit for the first time. For future reference, keep this guide in a safe, accessible location. If you need additional information or assistance, please contact U-Line Corporation directly. [. . . ] Use a soft sponge and rinse with clean water. Wipe with a soft, clean towel to prevent water spotting. DANGER RISK OF CHILD ENTRAPEMENT. Before you throw away your old refrigerator or freezer, take off the doors and leave shelves in place so that children may not easily climb inside. Remove the cabinet door if equipped and secure all interior shelves to the interior of the cabinet using a heavy duty cloth or package sealing tape. Interior Cleaning (As Required) · Turn unit off. Clean the interior and all removed components using a mild non-abrasive detergent and warm water solution applied with a soft sponge or non-abrasive cloth. Rinse the interior using a soft sponge and clean water. · Do not use any solvent-based or abrasive cleaners. These types of cleaners may transmit taste to the interior products and damage or discolor the interior. Maintenance Proper maintenance of your U-Line product will ensure efficiency, top performance and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets or other special considerations. Defrosting Frost-Free Models Frost-free models do not produce frost in normal operating conditions. WARNING DO NOT use any type of electrical heating device, ice pick, knife or other sharp instrument to defrost; this could damage the inner lining or refrigeration system and void the warranty. CO29FF 9 Condenser Cleaning Interval - Every Three Months To maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending on environmental conditions, more or less frequent cleaning may be necessary. WARNING Disconnect electric power to the unit before cleaning the condenser. 2 1 Figure 9 6. Remove the ice maker assembly cover (Figure 11). ULIN_0211_A Figure 13 Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (Figure 13). NOTE: This model DOES NOT have leveling feet. This model MUST be placed on a level surface to operate properly. ULIN_0056_A Figure 12 2. Locate the adjusting screw on the ice maker assembly control box. The adjusting screw is just below the minus (-) and plus (+) signs on the control box (Figure 12). NOTE: Make adjustments in small increments. Too large of an adjustment could cause the unit to malfunction. CAUTION Too large of an adjustment to the screw can cause the water to overflow the ice maker and can cause property damage. Turn the adjusting screw toward the minus (-) sign (clockwise) for smaller cubes or toward the plus (+) sign (counterclockwise) for larger cubes. CO29FF 11 Door Alignment Check and Adjustment IMPORTANT Properly aligned, the door's gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door's gasket to assure that it is firmly in contact with the cabinet. Also make sure the door gasket is not pinched on the hinge side of the door. 2. [. . . ] Set cube size smaller (See MAINTENANCE; ICE MAKER; ICE CUBE THICKNESS ADJUST). Clean condenser (See MAINTENANCE; CONDENSER CLEANING). Set cube size smaller (See MAINTENANCE; ICE MAKER; ICE CUBE THICKNESS ADJUST). Be sure freezer door is closed correctly. [. . . ]