User manual CAT EYE CC-6000 (MICRO)

[. . . ] Once this button is pressed and all memory is erased, it will be necessary to set the wheel circumference, time, etc. (refer to Main Unit Preparation) Fig. 5 B Fig. 6 Reset Operation: (Fig. 2) A AT Press left button to select any mode except total distance (O) and press left and right buttons together. Stored data of trip distance (D), elapsed time (T), average speed (A) and maximum speed (M) are all reset to zero. (In the total distance display mode, the current wheel circumference (A) or (B) is shown. ) MAIN UNIT PREPARATION B AT User must make the following setting according to instructions before the cyclocomputer can be used properly. Fig. 7 1. [. . . ] 115 Boulder, CO 80302 Phone: 303-443-4595 Toll Free: 800-5CATEYE Fax: 303-473-0006 e-mail: CatEyeUSA@aol. com Fig. 9 lever bracket rubber pad slide 3. Setting the Wheel Circumference (Fig. 5. 6) Fig. 10 This cyclocomputer is able to memorize two different wheel circumferences. One main unit can be used on two bicycles subject to buy another set of bracket and sensor. Two wheel circumferences, (A) 2155mm and (B) 2030mm, have been set befront fore the cyclocomputer left our factory. The (A) wheel circumference 2155mm (standard for 27 inch tire) will blink as shown in fig. 5. If you want to enter 2155mm and 2030mm, simply press the SET button. If you want to change, press either the right button to increase or left button to decrease the number. To change the number rapidly keep the button pressed. Once you reach the setting you want, press the SET button. If you want to set a second circumferfront fork ence, press the left and right buttons together before pressing the SET button. The wheel circumference 2030mm is displayed and blinks(fig. 6). triangle mark Then align the magnet with sensor zone (fig. 16). Meanwhile, the sensor shall aim at the main unit indicated by the triangle marked on the sensor. Then tighten the screw to secure the sensor in position. Cut the excess sensor zone Fig. 16 sensor band B with scissors or the like. SENSOR with TRANSMITTER SENS OR ZONE magnet Check points for sensor mounting: 1. Keep a 5mm clearance between the sensor and magnet. The magnet surface shall align to the sensor zone. The triangle mark on the sensor shall aim at the main unit. #169-6070 Wheel Magnet #166-5150 Lithium Battery (CR2032) Fig. 17 spoke COIN TEST Mount the main unit on the bracket. If current speed doesn't appear on the sensor zone main display, press either left or right button to release the unit from the power about 5mm saving mode. Then spin the front wheel to make sure the wheel sensor pulse symbol flickers. If it does not flicker, adjust the position of sensor until it flickers magnet normally. The mounting is completed and the cyclocomputer is operational. THE CORDLESS SYSTEM spoke Fig. 18 Fig. 19 OPEN The sensor picks up wheel revolution signal and transmits the signal to the receiver in the main unit. [. . . ] With Reset operation, it returns to zero. A T A A A Elapsed Time 0:00'00" to 9:59'59" ±0. 003% Elapsed time is measured from start to current point, in units of hours, minutes and seconds. At 10 hours, it returns to zero and counting begins anew. With Reset operation, it returns to zero. A Average Speed 0. 0 to 65. 9 miles/hr ±0. 3mile/h The average speed from start to current point is displayed within 27 hours 46 minutes 39 seconds (99, 999 seconds) or 999. 99 miles (km). [. . . ]