User manual CAT EYE CC-8000

[. . . ] may void the user's authority to operate the equipment. LIMITED WARRANTY 2-Year Warranty: Only Main Unit/Sensor If trouble occurs during normal use, the part is repaired or replaced free of charge. The service must be performed by CATEYE Co. , Ltd. . and the product needs service must be returned to CATEYE Co. , Ltd. When returning the product for CATEYE warranty service, pack it very carefully, and enclose the warranty certificate and instructions for repair. [. . . ] The main unit receives, calculates and displays the data. The approximate service hour of batteries is as follows: The main unit (receiver): --- Approx. 2 years (average 1 hour's use per day) The sensor (transmitter): ------- Total distance of approx. 10, 000 miles (16, 000 km) Note: To prevent external signal interference, the sensor signal reception range is restricted. For best performance, the triangle mark on the sensor shall aim at the direction to the main unit. The distance between the sensor and main unit must be kept within 45 cm. The signal reception range may shorten as a result of low ambient temperature or lowered battery power. It is advisable to replace the sensor battery before it fails. The battery service hours quoted above is the average for a 45cm distance between the sensor and main unit. · The cordless system may be interfered with in the following situation, so that main unit may display false data. Riding near railroad crossings and trains. Set to a desired wheel circumference in the same manner as the first circumference setting and press SET button to complete the setting. sensor 0. 00 to 999. 99 miles 0. 01mile The trip distance from start to current point is displayed. With Reset operation, it returns to zero. A T A A A T Elapsed Time 0:00'00" to 9:59'59" ±0. 003% Elapsed time is measured from start to current point, in units of hours, minutes and seconds. At 10 hours, it returns to zero and counting begins anew. With Reset operation, it returns to zero. A Average Speed 0. 0 to 65. 9 miles/hr ±0. 3mile/h The average speed from start to current point is displayed within 27 hours 46 minutes 39 seconds (99, 999 seconds) or 999. 99 miles (km). If either is exceeded, (. E) is displayed and calculation ceases. M Maximum Speed 0. 0 (3. 0) to 65. 9 miles/hr ±0. 3mile/h With Reset operation, it returns to zero and counting begins anew. Clock Time 0:00´ to 23:59´ ±0. 003% The current time is displayed by a 24-hour clock. M magnet Fig. 11 4. Selecting one of the two Wheel Circumference (Fig. 7) Set the Auto Mode to ON. (Refer to the explanation of Auto Mode function. ) While keeping the right button pressed , press the SET button. The first wheel circumference measurement will be displayed for a few seconds, then the second setting will appear. A sensor band B sensor rubber pad sensor band A Fig. 12 sensor band B sensor rubber pad POWER SAVING FUNCTION A 5. [. . . ] · Check the relative position of magnet and sensor periodically. · For cleaning, use neutral detergent on soft cloth, and wipe off later with dry cloth. Do not apply paint thinner, benzine, or alcohol, which may damage on the surface. screw sensor Fig. 14 spacer front fork How to Mount the Sensor on the Right Front Fork Leg. (fig. 11) Mount the sensor in the highest possible position on the right front fork leg. Adjust the position, clearance and direction as follows: (1) Insert the band B into the slit of the band A, and put the rubber pad inside of the band A (fig. [. . . ]