User manual CAT EYE HL-RC220 SOLO

[. . . ] * The package for Solo includes each 1 set of lamp unit(Spot Bulb), bracket, rubber pad; and the cord of the remote switch is single (not furcated). Lamp Unit Bracket (H-30) Battery Charger (AD-1250) remote switch from battery unit How to Adjust Angle of Beam angle of the beam (spot-beam) Adjust the angle of the beam downward (as shown in the figure ). The light is also adjusted 10° horizontally. (To adjust the angle, pull down the quick lever) HOW TO CHARGE (wide-beam) Battery Belt (2 sets) Rubber Pad jack battery charger (AD-1250) Remote switch Battery Unit (BA-220) plug FOR SAFE OPERATION (IMPORTANT) · Never short-circuit the terminal of the battery and the plug of the battery charger. It may cause the battery to overheat, resulting in fire or damage of the components. [. . . ] Standard charging time Note: The charging time and the operation time may vary hours depending on the use environment. the home power outlet 8-10 Precautions on seald-lead-acid battery · If the light is kept on until the power is completely gone, the performance of the battery is lowered due to the overdischarge of the sealed-lead-acid battery. When the light gets dim, turn off the lamp immediately and charge the battery. · A long period of non-use will lower the voltage of the battery due to natural self-discharge. If the light is kept on until the power is completely lamp body bulb WARNING!!Important Note gone (which is called "overdischarge"), it may shorten the battery life. Even when you do not use the lamp kit, charge the battery every few months. · Do not charge the battery for more than 10 hours. · If the lamp set does not serve the proper running time even though the battery is fully charged, the battery may have reached the end of its useful life. Replace it with a new battery unit (BA-220). IMPORTANT HOW TO REPLACE THE BULB When replacing the bulb, be sure that the bulb and the lamp body have cooled. Use only the CAT EYE 6V-10W Halogen Bulb (product code #534-0580/534-0581). Remove the lock ring by turning it counterclockwise. Remove the bulb and replace with a new one. Note: Do not rotate the bulb but pull it straight out. Tighten the lock ring securely while being careful of the waterproof packing. BEFORE FIRST USE: Before first use, charge the battery fully following the instructions on [HOW TO CHARGE]. Before every use, charge the battery fully following the instructions on [HOW TO CHARGE]. When the battery kit is not in use for a long period, the lampís operation time will be shortened due to the self-discharge of the sealed-lead-acid battery. bracket (H-30) waterproof packing lock ring pull HOW TO ATTACH THE BRACKET [Use two brackets for Twin. ] 1. Attach the bracket (H-30) to the handlebar using the appropriate rubber pads provided. Turn the quick lever (keeping it upright). Fix the bracket securely by pulling up the lever. To loosen the bracket, pull down the quick lever. [. . . ] 2 hours Charging Time: 8 to 10 hours Temperature Range: Charging: 0°C - 30°C Operating: ­15°C - 45°C Recharge/Discharge Number of Times: at least 150 times (until rated capacity drops to 50%) * The specifications and design are subject to change without notice. LIMITED WARRANTY 2-Year Warranty: Only Lamp/Remote switch and Battery Charger (Excluding bulb and battery) If trouble or damage occurs during normal use, the product will be repaired or replaced free of charge. Type your name, address, date of purchase and the situation of trouble clearly, and send it to the appropriate service center together with the product. Insurance, handling and transportation charges shall be borne by the customer. After being repaired or replaced, the product will be shipped back to the customer. [. . . ]