User manual CATA CATHPR8111X

[. . . ] Dévissez la vieille ampoule et l'éliminer d'une façon sure et écologique ; la changer pour une du type spécifié dans les Informations Techniques et remonter le protecteur. Thank you for choosing one of our products. We hope this household appliance provides you with the best service. Therefore, we suggest you read the instructions and suggestions contained in this manual carefully in order to use our products correctly. [. . . ] 3) At the completion of the set duration, the timer will stop the oven and give an audible warning. Also, the symbol "A" will begin to flash on the screen. After bringing the cooking function and oven temperature knob to "0" position. Pressing any button less than 3 seconds, it will stop the audible warning. Pressing " " for more than 3 seconds set the oven to Manual mode again to use the oven. Manual mode: In manual mode, only the day's time and the symbol " " lights up. The cooking duration has to be controlled by the user. Notes: In manual mode, to ensure the oven is not left on accidentally, after 5 hours no any button pressed, the timer will flash once a second to warn you the oven will enter standby mode. After a total of 10 hours, the timer will enter standby mode. When the timer is flashing in manual mode, press any button to reset the timer if you intend to continue using the oven. Or press " " and "+" together for more than 3 seconds to enter standby mode if oven will not be used. This function is used to cook according to the desired finishing time. The food to be cooked is put into the oven. The oven is adjusted to the desired cooking function and temperature degree. 1) Press " " button until you see "End" on the timer screen. Instructions for setting the correct time of day. ) 3) Press " " button to confirm, the day `s time will appear On the screen and the symbols "A" " " will light on the screen. Change time means cancle automatice progamme and enter into corresponding mode. If you need to reset automatic mode, need to stop setting the current mode, to set the automatice mode according to the above steps again. Spectification 1) Long press on "+" or "-" for more than 3 seconds, the date will progressively and rapidly increase or decrease in the rate of 5 seconds. 2) When setting each of the time function, if there is none operation for 5 minutes then it will return to manual mode. 3) When setting each of the time function, pressing on " " for more than 3 seconds can cancel current setting and enter manual mode. [. . . ] The blue conductor must be connected to the terminal marked "N". The brown conductor must be connected to the terminal marked "L". The lead must not reach a temperature higher than 50 ºC above the ambient temperature at any point. If the power lead is damaged, it must be replaced by a special lead or unit supplied by the manufacturer or it after-sales service. [. . . ]